Is Clamping Enough For Girth Gains

Clamping is very effective when it’s not over done. I clamped first years and have seen no permanent issues other than an increase in girth.

I feel like it’s the premier exercise for gerf. That’s just a personal opinion though.

What do you mean by gerf

I gained somewhere between 2/3 to1/2 of an inch really quickly clamping. It only took about 3 months, about an hour total every day stretched out between three or four sessions. I used a stainless hose clamp. The kind you use to hold a rubber hose on a steel pipe. The kind you tighten with a screwdriver. Looks like this:

I put it as close to the base as possible and only tightened it as much as was needed to hold the blood in. You put a wrapping under it of course. Tighten it up a bit then kegel blood in as you tighten it. Slowly keep tightening until the blood doesn’t leak out and you remain swollen, then stop. Don’t go any tighter than you have to. Leave it on 5 or 10 minutes, then take it off and have a rest. Do it again if you still feel good. Otherwise wait a few hours. I usually did it first thing after I got up in the morning. Then a couple of more sessions late in the day.

With the hose clamp you have the ability to finely adjust the constriction. Grind a flat spot into side of a dime, and silver solder it into the screwdriver slot and you have a handy key you can turn with your fingers. You could probably glue a 5/16 socket on too and that would probably also work. No other tools required. Go easy for the first while. Just a minute or two at a time and don’t be afraid to leave it a bit loose until you get the feel for it. Work your way into it.

Be advised, your penis will discolor doing that, mine did. But it went away a few months after I stopped. And the gain was absolutely permanent. It’s been a year since I stopped and it’s still there. I’m sure I could get more, but I like the overall look right now. I don’t want to end up with a 5 1/2 inch long coke can. Maybe I’ll do some more when I add some reasonable length. To give you an idea of how much I got. Make an OK sign with the tip of your index finger just above the joint in the middle of the thumb. Then move the tip to the end of the thumb. Hold some common items in your hand, a D battery, a hammer handle, things like that until you find two that roughly correspond. You’ll see girth gains look huge when they happen. Because when you double the diameter of a pipe, you quadruple it’s volume. It’s the gain that’s going to make a big difference, and you can get it fairly quick. I did anyway.

If you want to try that instead of the cable clamp, In the hardware store before you buy a hose clamp, run your finger inside it under the mechanism. Some of them have sharp edges inside from the manufacturing process of folding and stamping them. Some are a little bit better put together than others. Find the smoothest one you can, it’ll feel much better when you use it if there’s nothing digging in.

Whatever you do, like Titelist said, be cool, work up to it. Take it easy for the first little while when you do.

I gained somewhere between 2/3 to1/2 of an inch really quickly clamping. It only took about 3 months, about an hour total every day stretched out between three or four sessions. I used a stainless hose clamp. The kind you use to hold a rubber hose on a steel pipe. The kind you tighten with a screwdriver. Looks like this:

I put it as close to the base as possible and only tightened it as much as was needed to hold the blood in. You put a wrapping under it of course. Tighten it up a bit then kegel blood in as you tighten it. Slowly keep tightening until the blood doesn’t leak out and you remain swollen, then stop. Don’t go any tighter than you have to. Leave it on 5 or 10 minutes, then take it off and have a rest. Do it again if you still feel good. Otherwise wait a few hours. I usually did it first thing after I got up in the morning. Then a couple of more sessions late in the day.

With the hose clamp you have the ability to finely adjust the constriction. Grind a flat spot into side of a dime, and silver solder it into the screwdriver slot and you have a handy key you can turn with your fingers. You could probably glue a 5/16 socket on too and that would probably also work. No other tools required. Go easy for the first while. Just a minute or two at a time and don’t be afraid to leave it a bit loose until you get the feel for it. Work your way into it.

Be advised, your penis will discolor doing that, mine did. But it went away a few months after I stopped. And the gain was absolutely permanent. It’s been a year since I stopped and it’s still there. I’m sure I could get more, but I like the overall look right now. I don’t want to end up with a 5 1/2 inch long coke can. Maybe I’ll do some more when I add some reasonable length. To give you an idea of how much I got. Make an OK sign with the tip of your index finger just above the joint in the middle of the thumb. Then move the tip to the end of the thumb. Hold some common items in your hand, a D battery, a hammer handle, things like that until you find two that roughly correspond. You’ll see girth gains look huge when they happen. Because when you double the diameter of a pipe, you quadruple it’s volume. It’s the gain that’s going to make a big difference, and you can get it fairly quick. I did anyway.

If you want to try that instead of the cable clamp, In the hardware store before you buy a hose clamp, run your finger inside it under the mechanism. Some of them have sharp edges inside from the manufacturing process of folding and stamping them. Some are a little bit better put together than others. Find the smoothest one you can, it’ll feel much better when you use it if there’s nothing digging in.

Whatever you do, like Titelist said, be cool, work up to it. Take it easy for the first little while when you do.

Thank you for your reply , It is very helpful for me and informed me very well , I will consider and apply everythig you said , next day I will buy a hose clamp.

Hells no, anything that cannot be removed in a few seconds should not be used.