Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Results from last night's clamp test

123

Earlier I was too lazy to include in my post I start my extreme uli in 2 steps. First I wrap (sock+leather strap) with an erection and put on a hoseclamp which I tighten a little so it works as cockring. Then I edge for a few moments till I’m really hard again afterwhich I tighten the hoseclamp all the way possible.

My dick doesn’t get much more expanded till I start tightening and increasing the pressure inside. I don’t see a problem with clamping off an erection as it has always worked for me. If I used a cord you would have been right then clamping off in/outflow would not do anything, but with a clamp+wrap you squeeze a larger area and force extra blood inside increasing the pressure causing expansion (this does require kegeling during tightening so the blood is not forced out). You can see the effect in this post:

Piet - Piet’s 9-incher

Maybe this is pretty much what you are doing too but I just wanted to clarify my previous post.

Captain, with the little experimenting I’ve done, I used a terry cloth wrist sweat band. I plan to get some ACE wrap when I’m done with my break for hanging, so I’ll give it a shot. I agree, the muli-clamp is super easy to use.

Piet, I think what you are doing is different than just getting a 100% erection and clamping down. The edging gives you the super engorgement, so you are clamping off well above 100%, I suspect.


Twatteaser: the man, the myth, and the legend in his own mind.

Clamp down to the point of trapping or limiting the outflow of blood, but do not completely cut off the circulation. Without stimulation, you should be able to loose your erection slowly. With stimulation, you should have a pressure filled, veiny and throbbing erection, FULLY engorged. That's why I stated 120% erection.

Hmmm. That’s different than how I do Extreme Ulies. I tighten my clamp to the point where my cock is super engorged and whatever is left behind the clamp goes limp. Then I do some Horse Squeezes. This is not correct?

Just how tricky is it to cut off outflow without stopping inflow?? I may have to try this. Perhaps I’m not getting the most out of my Uli workouts?

>This is not correct?

Sounds like an extreme Uli. To do one you tighten enough to cut off all incoming and outgoing blood flow. It’s done in such a way that the final tightening builds a great deal of pressure. The base isn’t fully erect when you apply the thing, and during the set it will go completely flaccid.

With wrapping or clamping there are several levels. Bib described them here.

Originally Posted by hobby
[E]xtreme Uli. To do one you tighten enough to cut off all incoming and outgoing blood flow. It’s done in such a way that the final tightening builds a great deal of pressure. The base isn’t fully erect when you apply the thing, and during the set it will go completely flaccid.

I have so many questions but I’ll start with this one:
The base not being fully erect is very important because if it was rigid
you would surely cause severe contusions?


Yeeeeeeeeeaaaaarrrrrrrrrrgh! ~Howard Dean Illustrations & Diagrams PE -- What's it all about? Read this.

>The base not being fully erect is very important because if it was rigid
you would surely cause severe contusions?

If it’s too erect you can’t tighten enough to cut off all blood flow. And you might get bruised or injured trying.

It’s a balancing act. You need enough of an erection to build pressure in front of the Uli thing/hose clamp/whatever, but not too much. Tighten as the erection subsides. You end up being completely flaccid behind the thing with a great deal of pressure in front of it. Limit sets to 10 minutes max because there is literally no blood flow.

There are various levels of constriction:

Cut off outflow and inflow = extreme Uli
Cut off or greatly reduce outflow = what many are doing with cable clamps
Slightly reduce outflow = wrapping for girth

Originally Posted by hobby
Tighten as the erection subsides. You end up being completely flaccid behind the thing with a great deal of pressure in front of it. Limit sets to 10 minutes max because there is literally no blood flow.

Thanks Hob.
So, start to tighten as erection subsides and at the same time continue blood inflow
to achieve over 100% engorgement?

I think I’m also getting confused with the semantics.
When we say we want 120% erection, we mean it is our
desire to fill the penis with more than the usual amount of blood for our normal, full erections.
Is that correct?
Because to me “erect” = “rigidity”.
And rigidity is not necessarily what we want for X-Ulis.
Correct?

I’m sorry for this but sometimes I really need things broken down
for me to comprehend.

Hobby, the link in your post needs to be corrected.


Yeeeeeeeeeaaaaarrrrrrrrrrgh! ~Howard Dean Illustrations & Diagrams PE -- What's it all about? Read this.

My girth is about 1/2” bigger than normal while Ulied, sometimes more. Don’t get used to that temporary expansion - it will spoil you. ;)

Here’s how I do it. I attach at the very base:

Wrap moderately snug with either sweatshirt under Thera or Thera alone. Get about 70-80% erect, meaning actual erection, not just engorgement. Pull the wrap down toward the base several times while kegeling. This forces the blood into the shaft ahead of the wrap. After I get some good engorgement (bigger than a normal erection) I apply my Uli thing.

Start out partially erect. Put the thing on but not very tight. Kegel while pulling it toward the base same as with the wrap. Tighten a little while it’s held back. Repeat this a couple times. Then continue to tighten as the “erection” fades. The final tightening puts a whammy on the already super-engorged shaft. Think of it as blowing a balloon up to high pressure and then squeezing it. The final tightening is the squeeze.

Hope that helps. It sounds more complicated than it really is.

That link is the one I intended. The good stuff begins a few pages in. It’s one of the best threads we have here about wrapping for girth.

Finally, a step by step explanation. Thank you.
An excellent guideline for me.

Great link Hobby— lots of useful info.
It wasn’t working before, but I see that you fixed it.

After the final tightening, then what?
Sit back and watch TV?
Do I need to do anything to continue [i]inflow[i/]?
Massage? Stimulation? Bang it off the kitchen table? :)


Yeeeeeeeeeaaaaarrrrrrrrrrgh! ~Howard Dean Illustrations & Diagrams PE -- What's it all about? Read this.

Yeah, this thread is good. I’ve been waiting for a discussion like this and there’s a lot of great points, yet I still feel as if I’m doing my exercises wrong.

I pretty much end up with the same result you guys do: an engorged shaft that - while clamped - is larger than a normal erection. That’s the point, right?

So we can all agree that your clamped girth, no matter how big you are normally, will always be larger than your normal erection size, right?
But isn’t the point of this exercise to gain girth? So wouldn’t you slowly, over time, increase your girth? Thus, increasing what your “clamped girth” measurement would be during extreme ulies?

Sort of like your flaccid stretched length measurement… will your clamped girth measurement be the first place you’ll notice a GAIN?

I’ve been doing extreme ulies for many months now, and my clamped girth is always larger than my normal erection girth, but my clamped girth never increases… which leads me to believe that I’m NOT making gains doing extreme ulies. After taking a normal erect girth measurement, my suspicion was confirmed. Why am I not making gains??

I believe that I’m getting the proper expansion during each workout AND holding it there for the right amount of time, yet I haven’t gained in months. What am I doing wrong?

Also, what else could I possibly DO that’ll give me results? Aren’t extreme ulies called “extreme” because they are just that? EXTREME? If these do not work for me, what else could I possibly do to get gains in girth?

>After the final tightening, then what?
Sit back and watch TV?<

Set a timer and then watch TV, surf the net or pick belly button lint. Some guys use heat during the sets. For me it greatly increases fluid buildup, particularly in the donut area. I only heat before the first set if at all.

>I’ve been doing extreme ulies for many months now, and my clamped girth is always larger than my normal erection girth, but my clamped girth never increases…<

I’ve done them off and on - consistently for several months at one point. I’ve never had a gain attributable to EU’s.

>Also, what else could I possibly DO that’ll give me results? Aren’t extreme ulies called “extreme” because they are just that? EXTREME? If these do not work for me, what else could I possibly do to get gains in girth?<

If extreme doesn’t work try something less extreme. You may need to take some time off to decondition first.

Last time I gained a little girth was from low intensity, longer-duration expansion. This was after a long period of deconditioning. Intense stuff doesn’t seem to do anything for me other than cause discoloration. Maybe I go overboard and do it too often or for too many sets. I don’t know.

I have been using the multiclamp on and off for a couple of weeks. One thing I didn’t like was the lack of “fine tuning” of the clamp. By this I mean, the teeth are set to far apart and it’s sometimes I feel like I need to clamp tighter but just cant get to the next tooth. I saw this link product from somewhere (don’t remember) and used it for the first time last night. All I can say is Outstanding. Much more flexible amount of open/close area. Draw back, it’s not a quick release system.

It’s plastic and if you use a wrap, it should be fine. I feel i got the best pump ever using this. I was still pumped this morning when I woke up.

Hey Hughjorgan9,

Have you had any permanent gains with the cable clamp? What is you regular non-pumped girth? Also, have ever gained anything from just jelqing?

Thanks!

I am solidifying length gains, believe it or not. My girth has gained mostly at the base, but my volume has increased. It also feels thicker and hangs heavier. The best gains for me come from combining the clamp, jelq and occasional manual stretch.

HJ

Originally Posted by fubar993
I have been using the multiclamp on and off for a couple of weeks. One thing I didn’t like was the lack of “fine tuning” of the clamp. By this I mean, the teeth are set to far apart and it’s sometimes I feel like I need to clamp tighter but just cant get to the next tooth. I saw this link product from somewhere (don’t remember) and used it for the first time last night. All I can say is Outstanding. Much more flexible amount of open/close area. Draw back, it’s not a quick release system.

It’s plastic and if you use a wrap, it should be fine. I feel i got the best pump ever using this. I was still pumped this morning when I woke up.

I presume you meant you were originally using a Cable Clamp. IMO, those don’t work well for this kind of thing. You need something with finer adjustments that constricts the shaft more evenly. Cable Clamps are too oval.

The Multiclamp you linked is better (available at Wal-Mart in the RV parts section). It’s narrow and quite sharp on the edges, but works ok with a suitable wrap. Attaching/removing is slow. It doesn’t require any tools, which may be an advantage in some situations.

I still prefer an ordinary hose clamp.

Top
123

All times are GMT. The time now is 12:50 PM.