Make extender base more comfortable??

Has anyone figured out how to make the plastic base of an extender like the KR (from monkeybar) or X4 Labs more comfortable. I always end up about an hour into a session with a strong burning and pain in the skin directly under the base. I’m wondering if anyone has tried making a gel pad or something to fit between the base on the skin to take away some of the pressure.

I’ve seen a latex comfort set on eBay. You search penis extenders and you will see them. I believe there will be a picture of it with a base of an extender.

Thanks! I had not seen those before.

You could try to fashion one yourself with an old cloth of some sort to be placed underneath. Cut a hole in the cloth for your penis to go through and place the extender on top. Perhaps an old towel would work better for more padding.

What is your girth? I had this same problem. If your girth is above 5 you might want to look into getting the wide girth base from x4 Labs. The name is misleading. It’s more tall than it is wide but the point is that it doesn’t constrict your entire base. Also cut the top part off a sock and use it to pad the base against your skin. I will attach pics in a bit.

Pics attached

Some have used the adhesive backed foam, used in weather stripping, to stick on to the abdomen side of their extenders base ring. 3/4” or 1” will work best.

My girth is just about 5.25” at the base.

Thanks, I’ll give that a shot.

A mouse pad would work too.

One: I like to wrap some pre-wrap around the base. Pre-wrap is nice because it is cheap, and can be easily replaced when dirty.

Two: Keep the skin lose on the bottom. You may already do this, but pull a little skin through the base before you hitch up, and then pull a little more through afterwards. This is important for good stretches, and makes your stretcher much more comfortable.

Get either a very small cotton sock or a nice soft winter mitten. Cut a piece about 5” long. Feed one end into the inside of the base of the extender. Wrap the other end around the outside of the extender base. Make sure it extends far enough into the extender & outside the extender and it will stay in place with no problems.

These are cheap and you can wash them easily to keep them clean.