Hanging w/ a Vacuum Tube as the "grip"

Has anyone used a close fitting vacuum pump tube as the “contact” point on the penis then attached or rigged weights to it for stretching? Any ideas on why not to, difficulties with this, etc? I imagine that pulling the pump-tube may increase pressure on the glans which can become problematic but other than that I’m up for hearing any ideas. I’m thinking doing this on low pressure (~5 psi/atm or less) is best for that one reason. I figure I can glue some brackets on the side of the tube to connect string/cord to and then pass the string/cord over a fulcrum point with the weights attached on the end. With that I could control weight application by simply moving away to raise it.

Never tried it, but certainly thought about it. I’d make some kind of anchor at the top of the tube, and use a bungee cord as the weight.

The effect will be more or less the same as pumping at higher pressure though. It will relieve some force from the pelvic bone. And could be good for maintaining an erection in the tube by reducing the force required to milk the tube. Also raises the possibility of getting to pressures beyond atmospheric, but maintaining the grip on the penis as the tube moves up the shaft may be difficult.

I’ve actually been doing this since before I discovered thunders place. I have a hook stuck to the ceiling over my bed with a bungee cord that goes between the hook and my pump. I literally made my captns wench 5 minutes ago so I don’t know how the two compare yet. So far I think the pump is more comfortable. It’s also easy to wrap a couple small heating pads around the tube for warmth throughout the whole session.

Oh and it’s more comfortable since the bottom of the tube isn’t pushing into my body as hard. I’m definitely a fan of the whole setup. No idea what the long term affects are.

Penisdepot.com has this, I figured you’d have to put a toe cap on your tip though.

There was a chinese member who posted a blog about this on pegym, he said he had huge gains from combining pumping and hanging that way (I’m highly skeptical), but as Bible Dude said, I don’t see anything happening besides higher vacuum pressure (for which you don’t need an anchor and weights), perhaps the pull at the base is different and there are new possibilities to gain (I’d imagine particularly for base girth and length).

Hey, I thought you heard the hanging cylinder on penisdepot.com had good results?

? I heard of one positive feedback for such a device which I mentioned in my post that’s about it.

See here and the following posts:
https://www.peg ym.com/forums/b … dicated-pe.html

Also:

Bibmeister - Vacuum Pumping 101