What a wonderful hanger. Thank you Chickenchocker. Made my own and it is great. I had some problems getting the rubber grips so I had to improvise.
The only thing before I explain, if you have girth I suggest you cut your tubes 2 cm longer each and make the window length about 1cm longer. I got a little pinch with the shorter window.
Like I said I did not get the grippers so decided to use foam tube insulation used in Refrigeration and air-conditioning installations.
1. Select foam through which the tubes fit snugly
2. Cut the foam tubes the length of the window
3. Cut the foam in its length (split) on one side
4. Coat one tube and the inside of the foam with contact adhesive (Make sure the area is just the length of the window). Do not coat the foam where it will rest in the window.
5. Wrap the foam carefully around the tube so that ends join at the back of the tube.
6. Wait till it is nice and dry.
7. Repeat 4 ; 5 and 6 for the other tube
8. Cut two sheet out of Speedo swim cap (I used the white) with enough length to cover the foam completely.
9. Wrap around the ( Fairly tight but not to much) foam covered tubes and secure with a piece of masking tape at the back
Note: You can hang directly on your dick now. It is very comfortable. I like heavier weights and I felt a little discomfort so I decided to do the following (I am uncut)
10. I selected and cut a piece of the foam that will fit snugly around my dick about 3cm in length. I have to roll it on like a condom.
11. Cut two pieces of latex swim cap as above. One for inside and one for outside.
NOTE: You have to work fast here. You will glue the latex onto the tube while the glue is still wet. No waiting to dry as you can not use rubber cement on latex directly. Latex reacts to fast with solvents in the rubber cement and crumples = messy!
12. Get a piece of tube or pipe to hold the foam. Smear the glue and immediately start wrapping the latex.
13. Now turn the foam inside out after waiting a little while for the glue to dry.
14. Repeat 11.
15. Note: getting the Foam Latex tube on. Push both your index fingers inside and stretch the tube open only a little and just enough to get it over your dick head. My foreskin automatically rolls back at this point. Roll the tube back wards inverting it, a bit like rolling a cock ring on. This inside will now be on the outside. Use your fingers to wiggle it in position. I grasp my cock and foreskin with left hand and stretch with one finger of the right hand the tube. That way I get the tube close to my base. You can now start hanging and guarantee absolutely no slipping.
I hang up 30 minutes with 3kg even walking with it swinging it lightly and even getting a bit of a hard on when I do PC’s. No discoloration or cold head.
NOTE: I used a hot solder iron with thin point to make the holes and seal the string ends.
Happy hanging and Kudos to Chickenchocker.