A newbies pumping conculsion.

I am pretty new to pumping. I first bought a 2.25”x9” set up from lapdist.com. I used this for a couple of weeks, and decided to buy a 2”x10” tube from the same company. I got it in the mail and did a few work outs with it. But last night, I put in a serious workout with it and got much better results.

The smaller tube made my dick grow longer and fatter! My dick reached alittle more than 8” in the 2” tube. My best results in the 2.25” tube was a hair more than 7.25”. My girth at the base went from a bit more than 6” non pumped to 6.5”! Midshaft was 6.25”! I will use the 2.25” tube every once in a while to mix things up abit.

So, if I could do it all over again, I would start with the smaller tube! I THINK I will get better and faster results with the smaller tube.

One downside from last nights workout, I got a small doughnut of fluid from going alittle too aggressive. I just got excited seeing my results and kept going when I should have stopped!

So for people just starting out, do yourself a favor and get a smaller tube.

Matt

Matt,

You’re exactly right. With pumping it’s best to use a smaller cylinder first and then work up into the larger cylinders as you get better and better expansion. Be careful about being overaggressive. It’s very tempting, but in the case of pumping “more is not necessarily better”. Good luck.

Peforeal

It was so encouraging seeing the results last night! The sight of my expanded dick in the tube last night was insane!

But ya, I will have to think with the big head and not the small one from now on:)

Pumping gives such immediate (if temporary) initial visible results. Thus the temptation to do more. I’ve been there and done it all as a newbie, so I can speak from experience. It’s a great technique and has probably given me most of my good gains combined with some jelqing.

Thinking with the head above the shoulder, rather than the one below the belt, is difficult for most guys, but it can be done.

So for people just starting out, do yourself a favor and get a smaller tube.

Matt

That is exactly what I have been trying to tell people

smaller tube and a very small cock ring but if people use a cock ring they also need a inner tube instead of the thing that comes with most pumps and cylinders because if you use a inner tube it can keep a vacuum better.

why you should also use a ridged “hard” plastic or metal cock ring is because it will allow blood to enter the penis chambers and not allow it to leave the penis chambers, so the more blood that enters the penis chambers the bigger the penis will get.

I had a similar experience. I read that pumpers get better girth gains than length gains, but I wanted length. So I got a 1 1/2 ” tube. I figured that it would hug the sides of my cock, so the vacuum would have to cause length gains. I later tried a 2” tube, and got greater length increase during the session much more quickly, plus girth increase, than with the narrow tube. Seems the cock needs to expand in both directions proportionally.

The best cylinder to buy is one that fits correctly and allows for expansion in all directions. Generally speaking, one that is at least 1/2” larger then your erect girth but smaller then 1.0” larger then your girth.

The best way to use your larger 2.25” tube is to incorporate the staging technique. Pump up first in your 2.0” tube until you reach your 6.5” girth and then switch over to the 2.25” tube and continue.

Going for more than 1” of girth expansion in a session, although impressive and fun, is generally all for show and will produce little if any permanent results because it starts becoming external skin bloat instead of internal structure expansion.

And for the tip of the day. :) Pumping at low pressure for longer time is much more beneficial then pumping at high pressure for short (or long) time.

This seems to be the case, too, in Condom Pumping (see the stickie at the top of the forum). A tighter condom gives a better post pump result.

If your smart enough to take some advise…take THIS advise!

My base girth is about 5.5in, mid-shaft 5.1in.

Cylinder sizes available:
-1.75in diameter = 5.5in girth, this is 1/2 in more than mid-shaft girth (OK), but exactly base girth (too small)

-2in diameter = 6.2in girth, which is 1.1in more than mid-shaft (too much), 0.7in more than base (OK)

So based on my mid-shaft girth I would get a 1.75, based on base girth I should get 2in cylinder.

I already have a 2 in cylinder but I would get the 1.75 if I have to

5point5

The 2.0 should do just fine. Base girth is the controlling factor.

thanks gprent, I am glad I can save the money.

If you use a penis pump do yourself a favor and use a very small cock ring while pumping. I use an inner tube as a cock ring and it works good for both making the penis longer and bigger rounder.

what it does is helps keep the blood from leaving the penis chambers or penile chambers ever which way you want to say it.

A small cock ring is most if you want to see lasting results