Getting new pump, did some measuring

So i’ve been slowly doing pe since I was about 18, perhaps younger, but I wish I knew then what I do now. I don’t really have before measurements, i’ve just liked the idea of constantly growing bigger and bigger. So yesterday, we placed an order for some toys and my girl wanted to measure to make sure. So I found our tape and had a bit of a chub going, nothing to firm, but i’ve been exercising, so it’s always kind of ready to spring to action kind of firm. The tape was placed just infront of my balls, at the base and it said 7”. It was tight, there was skin muffintopping over the tape, just so we got the actual girth. We did some bad math and came out at 2.25” circumference. I’m getting both a 2.75” tube and 3.25” in the next couple of days. Can’t wait! They’ll be 9” long, so I hope to reach the top of them in a couple months or years. I probably won’t post again for a while, but feel free to ask questions if you have any and i’ll try and get to them in some manner or what not. Thanks for the outlet, there’s really nobody else I can brag about this to. Mind you, the feeling of having to go extremely slow when first starting sex every time is a great bonus. lol.

2 posts in 10 years! Have fun with your new toys Likwid!

Just to get the nomenclature correct, your girth, which is the same as your circumference, is 7 inches. That means your diameter is approximately 2.25 inches.

Now, based on the chart in the selecting your cylinder size thread: Selecting Your Cylinder Size you should be getting a 2.5 inch diameter cylinder and that will fit your 7 inch girth correctly by giving you room to grow without being so large that your balls will be sucked into the tube when you pump. So a 9"X2.5" cylinder would be my recommendation for you.

Thanks for both advice and good wishes!

I have had too big of tubes in the past, and did get some balls in the tube action, which isn’t fun. I do however, expand quite rapidly in a tube, and while 2.5” would have been a perfect fit, they didn’t have that size in my budget range for getting two tubes. Would the 2.5” tube help with length more? or will pumping only give me minimal gains length wise? (I am not looking for instant growth, keep in mind that 5 years of good pe will get you solid results). Either way, i’ve been stretching and noticing an improvment in some length.

What helps with overall pumping results is a tube that fits properly and is comfortable. When your pumping experience is enjoyable, you are more likely to stick with it. I would buy that 2.5” diameter tube first.

I noticed that if girth is 7”, but mid is 5.5”, the 2.5” cylinder could present problems with sucking in the testicles. At 2.25”, you can get some girth expansion further up the shaft. If you want length, go with the smaller diameter tube so that as base girth fills tube, pressure will build higher up & force greater length.

Well, it looks like I’m going to buy a 2.5” one day. Unfortunately, I didn’t check with you first. :( No worries, I’ve used larger tubes in the past, and that’s where some of my current gains have come from. Thank you for the help though!