Home made pump.

I used a small rubber o-ring today with a 1 1/2” diameter in the pump and I got way more discolouration than I ever have even though my first session only lasted 8 minutes.

I removed the ring for the remaining sessions and got better base inflation after that and a tighter seal at the base, allowing more pull on the tunica.

The ring stays on nicely even when I’m flaccid though, so I’m going to wear it throughout the evening to see what happens.

Getting a good half hour in five minute intervals per day now and noticing fuller flaccid all the time and great EQ on demand.

I began this adventure with a 2” diameter tube and all has been well, but in the interest of curiosity I built a 1 1/2” pump last night and tried it today and, holy shit what a difference!

With the 2”cylinder it takes several five minute sessions to get fully engorged to the point where I m packing the walls, but with the narrower cylinder it takes only 30 seconds or so before I m tight against the walls and pulling hard for length.

My only concern is that the narrower cylinder is hard on the skin unless I use water first. Dry just grabs the skin and tugs as I expand which is painful and will cause blisters over time.

Use some lube with the smaller cylinder. EVOO works well. I always use it when I pump wet or dry.

I could see that I’m going to need something if I do more time in the tube.

The water works well but dries quickly.

In the hot bath the pressure is way more than I’ve experienced so far.

I second this, even with water I use some lube. I can easily get a friction blister if I don’t.

The smaller cylinder is going to make your length skyrocket both flaccid and erect. Be careful not to get blisters on your glans. I recommend measuring your BPEL, mark that accurately on both of your cylinders. Use just enough vacuum to exceed that length towards the end of your routine. You’ll see just how quickly you’re surpassing your erect length.

Thanks. I just saw this post now.

The narrower tube pulls buck more and I find less puffiness as a result, but I’ve always been after length so that fine by me!

That’s exactly what you’ll get. It’s going to be fun to track your progress.

Cheers mate!

I used both the 1 1/2” and 2” cylinder alternately for about an hour in five minute sets, beginning at about 30% erection and ending 110% erect.

I hit the PONR unfortunately, even though I prefer not to while pumping, but no real harm done.

No soreness or redness, but a feeling of fatigue of the inner structure of my penis, which is what I’m aiming for.

I have noticed a consistent fuller feel to my dick throughout the day and certainly when having sex with my wife.

I am concerned that I might have lost length, but I’m glad about the other effects though.

If you are losing length (its a form of turtling), just cut back a bit. You should have a heavier, longer flaccid during the day after proper pumping, if not you are probably doing a bit too much. Either decrease time or better yet, decrease vacuum force.

I have the heavier longer flaccid, in fact a little too much in some jeans.

I’m hesitant to measure yet, but probably around Christmas I will check for gains.

Thanks for the heads up mate.

I had the best session ever in the narrower cylinder today.

I discovered that once I’m hard I can jelq and stretch the ligaments.

I lost track of time doing this and spent almost half an hour straight under pressure.

No harm done, though the unit is quite fatigued as a result.

Sounds like you should be getting some gains by now.