Pumping for length and cylindrical shape

Gents,

I have been interested in using low vacuum pumping to help remove discoloration from hanging and assist in attaining my length goals. I would also like to get a more cylindrical shape, as I’m afraid jelqing is accentuating my hourglass/baseball bat shape. I have girth goals, too, but I’d like to reach for length, first.

I have a 2” ID x 9” cylinder and at my girth (6.25”), I’m already packing side-to-side when I slide into the cylinder and 4” Hg packs it all the way around at the circ scar to about 2” below it. There is a gap where I’m not packing for about 1.5-2” below that, pretty much all the way around the shaft. It isn’t a big gap, but I don’t think I have a hope of expansion there if the tube is packed above it. Since I’m pumping primarily for length, I don’t want to move up to a larger diameter cylinder. Wrapping is out of the question because I won’t fit into the tube with any wrap around that area, unless I go in without an erection and wrapped to prevent normal erection girth.

Are my goals irreconcilable, or is there something I can do to to address both?

Hey Slip. You have made those kind of gains in less than six months and you are asking questions?????? Congratulations man. You ought to be holding teaching seminars. Keep doing what you are doing. My routine is similar to yours but I stretch for at least 20 minutes. Stretching is great and I have added at least a quarter of an inch erect (maybe more) and more than that flaccid in four months. Stretching with heat is my next venture. I think you need to keep your present tube. Consider the stretching and remember that those who have had good results from clamping say that they gained lots in girth in the base area that was clamped. This gives me hope because I like you have a baseball bat shaped dick and want to be treetrunk. Good luck man.

Haha - thanks Tank! My gains have come from jelqing and a bungee stretcher that is similar to a wenchette. This pumping thing is all new to me, hence the questions. Thanks for the advice.

So if you are expanding at the base and also at the head, does that mean that the shaft will not have much chance of expansion??

Basically yes, that is my concern. I’m looking to the pumping pros to give me an idea. My guess is that I can: A) move up a size and focus on pulling out the girth in that area by wrapping the upper section of the shaft or B) deal with it and keep aiming for length, but can’t C) address both. In that case, I’d stick with the smaller tube for now and continue trying other exercises to address the shape issue, like horses, clamping, etc.

Slipstream,

I’m also very interested to hear from the Gods of pumping to advise of what to do.

Although I haven’t pumped for long I am having the same issues as what you have described.

Have you thought about using something like a cocktail straw to allow pressure to get to the lower area. I don’t know if it will work, but it is worth a try.

slipstream,

This is the method I used when I had a similar situation going on while pumping. It worked for me to help even out my girth from the base of my shaft and upward when I was getting too much expansion in the upper shaft area below the glans.

Peforeal

This is a very interesting idea. For guys with large heads or baseball bat shape, all you would need is a small transfer tube inside the cylinder allow the pressure to equalize between the top and bottom of the cylinder.

:up: :up:

elroymb, that is an interesting idea, I’ll try it. The simplest ideas are often the best.

peforeal, what did you use for wrap and what was the tube size relative to your girth at the time?

And if you don’t mind a few more questions… Do you recall your girth at the skinny part of the shaft and at the part that constricted the flow, or if not, the approximate difference between the two?

Your growth (especially girth) was so huge that I am skeptical I’ll be able to replicate your results. I tend to think that anyone with double (or in your case triple) volume growth has some genetic advantage - like a single layer tunica or extremely adaptive layers. You mentioned that you have just received an air clamp, so I’m assuming that you are still actively PEing. Have your stats changed from your last entry in Size’s DB?

Thanks for your suggestion.

slipstream,

For wrapping I used some ACE self-adhesive bandage material. When I first started to wrap I was using a 2.0” diameter cylinder and wrapped the area very tight below the glans where I was getting too much fluid buildup and expansion, cutting off vacuum to my middle shaft area. Later on as packing became easier, I used the same wrapping technique in my 2.5” diameter cylinder to encourage more expansion below the wrapped area. I don’t recall the exact difference in measurements between the different parts while in the 2” tube which is the limiting factor.

Yes, I just received an air clamp a few days ago, and so far I am pleased with using it because of its ease and comfort. I won’t be throwing away my regular cable clamps anytime soon, as they have served me well, and I can use them easier under my clothes for stealth clamping.

My stats haven’t changed significantly in erect size. In fact, I’ve been at an erect length plateau for a couple of years. What does continue to still improve for me is my flaccid girth and length. I’ve also started to experiment recently with the MaxVac hanger to try to jumpstart some new erect gains. My goal is still to reach the magic 8” EBP mark.

Peforeal

Thanks, Peforeal. I wish you the best of luck in breaking the plateau and continuing your tremendous gains.

Thanks, slipstream. I can use the extra positive thoughts.

Peforeal,

You should really consider a decon break to jumpstart length gains. If you have been clamping really intensely, it might require a month or two of deconditioning.

sparkyx,

You’re probably right, but damn if I can stop PE’ing for even three weeks. In fact, I just came back from a vacation away from the islands and didn’t PE during that time. Part of my difficulty in taking a long break is that I actually enjoy the PE process and I continue to make slow gains in flaccid size, especially girth. Also, overcoming my initial small flaccid size was always my main PE goal. Reaching the 8” EBP mark is now more about personal satisfaction, ego and goal setting. Because I’m pretty content with what I have now, I guess I don’t have the urgency to have to drastically change practices. I will take the decon break into major consideration if my latest venturing into using the MAX VAC doesn’t help break the plateau.