Pumping With A Baseball Bat?

Has anyone ever seen what happens in the pump when someone has a baseball bat shape? As in, the top half packs before the bottom half. When I’m in the tube it’s not a huge difference, but the upper end of my unit looks like it will pack before some of my shaft below it will. I’m curious how this would work if it happens.

Because if it’s fully packed that would mean below it it would be getting very minimal if any pressure stimuli.

Curious if anyone has ever seen this before and how things worked out.

That will never happen with me, but when you reach that milestone, just invest in the next cylinder size up.

I’m shaped like a baseball bat. I’m 5 1/4” after the gland and just under 5” at the base. I have no problems. Get a cylinder based off on your biggest girth.

You can also apply a wrap around the largest girth to give the base girth time to experience vacuum.

That gives me an idea. I’ll wrap the base.

Hmmm alrighty. Was just curious since it seems I will pack higher up then the lower half of my shaft. My units shape is interesting, almost like an hour glass kind of thing. Thicker at the very base, than thins out slightly and than gets a bit thicker again towards the glans end.

At least iam able to pack the base, that seems to be the most important for helping to get a good seal.

I do wonder if in the future some wrapping might help. Although I don’t like to mess with things too much, but if it didn’t have any possible negatives effects I could definitely try it.