Selecting Your Cylinder Size

All right , the base of my left cc doesn’t fill up well, I don’t know why, but perhaps pumping could help. I’ll give it a try when they ship the pumps again, and when my wallet is filled with the easy-to -beat elders’ money. (<= humor)

So I went to my local “sex shop” and acquired my first pump today. However the pump is much too large for me to use according to this sizing chart and my initial testing of the device, so where can I get a good cylinder with the pump and gauge for a good price?? I only ask about price since I’m out $60 from the one that doesn’t work as it should. Unless someone can suggest a way for me to be able to keep the seal good without my sack pulling into the tube and the pressure still not staying where it should.

This is the best deal going for a Leluv system:

Find your cylinder size using our size chart: Selecting Your Cylinder Size

I want to go mainly for base girth.
On the page where I want to buy a conical shaped cylinder they tell me to get a diameter which is 1 -1,5 cm(0,4-0,6 in) bigger then my base diameter.
I have rather wide dick.
So while OP says according to my total girth I should get a 2.00 cylinder
.. it would mean that I would erect fit into it diamter wise jsut about with not much room to pump the base.
So I guess I go for at least 2.25 so I have some room to expand diameter wise.

I plan to purchase a pump sleeve for the base and ballstretcher/ring to avoid balls going inside.

Walter, did you buy one and what was your decision and outcome?
As I have ,like above written, almost the same problem.

Here you go schwanzie Thickwall cylinder + pump from amazon

I have just moved from a 2.00 to a 2.25 and found I should have done this ages ago

Hello, some feed-back will be helpful :) .

I have about 6.3” BEG, but about 5.6” MEG (almost 1” difference). I go for girth/length.

I have the option to select between 2.25” straight shaped pump versus 2.37” cone shaped pump. Is hard for me to decide.

Additional question: or is better to use a 2” pump? :)

Thanks in advance

You won’t even fit into a 2” cylinder. The 2.25” is the one for you.

Can you give me a link to the 2.37” cone shape cylinder? Not sure which one you are talking about.

http://www.drug store.com/calif … -pump/qxp331476 .

I see on this site it say 2.25”, but 6cm is 2.362”. Is not cone shaped like I thought :|.

So.. 2.5” versus 2.37” ? Matter of preference?

In my humble opinion you want a cylinder better than this one, and a gauge.

Definitely do not buy the drugstore.com pump. It is low quality, no gauge and will not last long.

Where do you plan to buy the 2.25” cylinder pump?

Probably almost same as cheap. :)

That pump is also no good. The money you spend on that pump is going in the trash.

Even with the cost of postage, I think this is your best deal for a quality pump with a gauge that will last a very long time:

There are also professional pumps available from Europe.

I disagree. It will fit. His base girth is likely extra skin and fat. The 5.6” midshaft will expand well in a two inch and he will get a greater length pull in the 2” tube than the 2.25” tube.

Interesting, I ask myself from a time. Possible with some squish it will fit. I think I will take 2 and 2.25, for steps process.

Thanks to both of you, inspirational, like always