Silicon Sleeve Pumping

The baby powder certainly seemed to save the day. dickerschwanz gave a good explanation as to why the baby powder could work - Prevent blisters wIth vac-hanging (p. 2) see post 27.

I have been pumping consistently for 1 hour at 4 - 14” Hg each night using the glans protector with baby powder but have not used the sleeve for 3 days as I was packing the sleeve. I found my fluid build up gradually increased, comparing it at the end of each session. I did a jelq session immediately after pumping and again early the next morning when my EQ is best. I found this jelqing virtually removed all my fluid build up.

My next approach is try the sleeve on alternative nights and see how that goes. When I get around to getting a larger cylinder I will wear the sleeve with each pump. I also have a 2 1/4” leluv cylinder I can use with my air pump. One option I might try is a 30 min water pump session followed by another 30 min with the air pump and larger cylinder. Has anyone tried something similar?

Another thing I found was to fit a short silicone sleeve at the base of my cock to help me get erect before I fit the sleeve and glans protector. I understand it is good practice to pump erect and suspect that might reduce fluid build up.

Regards
Austfred

Yes, jelq remove fluid.

Yes, i have done small cylinder to a big one: when i pack a 2.25 inch cylinder in 5~10 min, i move to 2.6 in same section and so on, it works. I’m not pumping anymore now, just telling you my experience.
Actually you should do this only when your dick get the 2.25 inch size (diameter) and not when it is fluid build up - this means that if you can pack so fast at this size your dick is this size or almost, when i say pack 2.25 inch i’m not with fluid.
Do this to work in your thickness.

My English is not the best, hope you understand.

Pumpbra,

Thanks for sharing your experience. Most helpful

Regards
Austfred

How much powder do you guys use? I also get blisters from the head protector. The sleeve pushes the protector forward a bit when i lose erection a bit in the water tube, and it creates a big vacuum camber and blisters will come. Does the powder prevent that?

mikujamanni

>How much powder do you guys use?

I put a generous dusting all over the glans and the groove behind

>The sleeve pushes the protector forward a bit when i lose erection a bit in the water tube,

My experience is similar. Find it very difficult to avoid no air inside the protector

>Does the powder prevent that?

So far it has for me and I pump in the range 4 - 14” Hg for a 60 minute session.

I understand the powder dries out the skin and that reduces the chance of a blister.

Austfred

I am new here and have been into this for about 10 years .. Silicone sleeves and toe caps are new to me I do like it .. I recently ordered and have received the silipos to me it seems if ya turn them inside out they stay tighter to the skin .. I am testing this and don’t go to anymore than 8 Hg with a ctc DP-4000 in a pyramid program

sweeternuts.

I found turning them inside out did not seem to make a difference. I sometimes get an air gap inside at the front but does not seem to matter provided I use the baby powder. I fit the glans protector first and then the sleeve with the front edge of the sleeve on top of the back edge of the glans protector. That keeps it in place. Once you pump up I find the glans swells to fill the protector.

Austfred

I received the toe caps last night.. The one I was using I sliced a to match my urethral opening and that seems to help more than turning it inside out (no baby powder) .. I hope upon practice I don’t get that unpleasant sensitivity that comes from pumping “too often” unless I’m the only one who gets that.?

I’ve attempted wet pumping using a vessel to catch water and it seems like to many extra steps I enjoyed it with a hand pump, seems like to much of a hassle with electric .. I do use an infrared heating pad around my cylinder

sweeternuts

> The one I was using I sliced a to match my urethral opening and that seems to help more than turning it inside out (no baby powder) .

Not sure what you did here but I found the longer the better in terms of keeping it on. When fitted on an erect glans I found it somewhat shrank the glans but quickly expanded once in the cylinder under vacuum. The powder seems to work by drying out the superficial skin layer

Regards
Fred

> Not sure what you did here but I found the longer the better in terms of keeping it on. When fitted on an erect glans I found it somewhat shrank the glans but quickly expanded once in the cylinder under vacuum. The powder seems to work by drying out the superficial skin layer

Fred,

I only air pump currently .. I made a slit in the material to coincide with my peehole .. Thinking maybe I could pee with the sleeve and toe cap in place and that went horribly. What I think it did do is, create a vent for air to escape when the pyramid ramped back up removing the “bubble” as I expand

And I agree 1000% about whereing it all the time since I am cut I think it could be very effective at increasing sensitivity like a foreskin prevents from happening to begin with I understand what you are saying about drying out the skin of the glans for a friction “adhesion” .. I also find there’s a difference if you roll root to tip or tip to root

What are your thoughts?

Also I’ve read that absilicone isn’t the best at replying to emails or shipping orders and these sleeves aren’t searchable on amazon anymore .. That could be a problem

sweeternuts]

> I only air pump currently .. I made a slit in the material to coincide with my peehole .. Thinking maybe I could pee with the sleeve and toe cap in place and that went horribly. What I think it did do is, create a vent for air to escape when the pyramid ramped back up removing the “bubble” as I expand

I get it. Not sure the slit is a good idea. I use the cap mainly to keep the powder near the glans to stop blisters.

>And I agree 1000% about whereing it all the time since I am cut I think it could be very effective at increasing sensitivity like a foreskin prevents from happening to begin with I understand what you are saying about drying out the skin of the glans for a friction “adhesion” .. I also find there’s a difference if you roll root to tip or tip to root

I am uncut but believe the extra sensitivity comes from protecting the glans from every day wear (eg rubbing against clothes etc). Not convinced wearing the cap while pumping would make a material difference. To fit the cap I stretch it out with two or more fingers and fit it tip first trying to get the end as far past the corona as possible. I then fit the sleeve using a sleeve applicator rolling it back from the front with the applicator front edge just in front of the applicator. Once the sleeve is fully rolled on back to the base I then temporarily roll the front edge back off the sleeve so I can remove it. Then roll the sleeve forward over the back of the cap. Sounds complicated but pretty straight forward.

>Also I’ve read that absilicone isn’t the best at replying to emails or shipping orders and these sleeves aren’t searchable on amazon anymore .. That could be a problem

Think they are a small outfit and can be a bit slow. Have always delivered though in my case. Pity there is no one else making these soft sleeves.

Austfred

That’s what I was saying I wear it all the time currently, I’ve noticed that my glans is more pink and moisten when I take the cap off to pee there are layers of skin releasing, so yeah If I had kids they wouldn’t be cut

I have never been prone to blisters , but I’m a redhead as well

I didnt have a problem absilicone with my first order along while back .. Placed my second today

I think I can improve on there design of a pumping sleeve

sweeternuts]

>That’s what I was saying I wear it all the time currently, I’ve noticed that my glans is more pink and moisten when I take the cap off to pee there are layers of skin releasing, so yeah If I had kids they wouldn’t be cut

I get you again. Was not aware you were wearing it long term. Not sure what the compression effect on your glans would be over time. Have you thought of using a cut off condom for that purpose. Might put less stress on the glans while shielding it.

> I have never been prone to blisters , but I’m a redhead as well

I was not either till I overdid it with a Vacextender (ioo much tension and for too long). Now I have to be more careful

>I think I can improve on there design of a pumping sleeve

Would be good if we could make our own. I know others have done so and there are posts on Thunders about how to do it. The only issue I can see is managing to get a soft enough silicone compound for a pump sleeve. When I finish sorting out our new house and have the time I will seeif I can do it.

Regards
Austfred

Fred,
>I get you again. Was not aware you were wearing it long term. Not sure what the compression effect on your glans would be over time. Have you thought of using a cut off condom for that purpose. Might put less stress on the glans while shielding it.

The Cap Is Cool The material it’s made of compresses at first but everything normalizes so circulation isn’t a problem

I’ve tried hanging before wasn’t a fan

You’ll have to pm me for the rest at this point