Buckfever's progress report/bananaman story.

I couldn’t agree more. The other thing that I’ve noticed is that with the extender use the crease at the top of the shaft is being replaced with a spot higher up, so that with the fat pad reduction the NBPFL is greatly enhanced. So that’s all that’s left is just to take the “pussy around the penis” effect out.
And I like that term. Cuts to bone, no Fn around, just get it done.

1/4/2018 Update

Yesterday PM:
34%@18.5 mintues
Low tension @16 minutes

Today AM:

100% max tension @ 63 minutes
Max tension @ 10 minutes

For the second session yesterday I should have stayed at low tension and got the 60 minutes. Again overzealous, again reminded of the need for temperance. I’ll try not to make the same mistake later. Good session this morning.

1/4/2018

Second Session:
Low tension @ 10.5 minutes interrupted
Followed by
Low tension @ 60.5 minutes

So I was able to contain my vigor for the second session and stay with the low tension. Small interruption but was able to get back on it right away and log a continuous full hour. And that’s it for the day. We’ll see how it goes from here, just got to thread the needle.

1/5/2019

100% @27 minutes.

Pressed for time.

1/5/2019

Low tension @ 60 minutes

Pleased that I have been able to pull it back and get the session duration back up. Feels like I’m just weeks away from consolidating this extender length should the schedule allow it. We’ll see. My life remains complicated.

1/6/2019

34% @ 60 minutes.

Had a conflict regarding the morning session so decided to keep the tension at 34% to ensure that I get the duration in. For me right now this is the key, to keep the duration up and then I’ll slowly bring up the tension and we should finish this. There’s not much more to do here at this extender length as long as I can stay disciplined.

hey Buckfever, do you have any photos of your noose/velcro set up? I too use the noose and it’s consistently the limiting factor, although I came up with a system where I double wrap a hair tie followed by duct tape around the cradle after securing the noose :)

anyone tried this or have recommendation/thoughts on using an ADS or specific brand? https://stealthformen.com/ (corkscrew)

There is a very long Stealth thread on the site if you search for it. The founder of the site was a member here.

Please ask these questions in general forum not progress reports.

thanks I just found it, sorry!

1/8/2018

Ran into an equipment problem the last 2 days. I’ve actually run out of functional nooses for the cradle type I was using and can’t find a supplier for the exact size noose that I need. I have bought different noose cradles and this afternoon will start the process of getting into functional equipment.

It sucks because I really had that system down.

Sorry to read this Buck. Best wishes for finding a new solution. I wish I could be of some help, but my experience is limited to the strap and when I run into device issues I just give more money to X4, who charges more than I should be paying.

Well I may wind up there too, at least X4 is likely to be around.

1/8/2018

Yesterday:

33 minutes

Today:

55 minutes

More importantly I did not come up with a solution. So I rather suspect I’m on maintenance for a while till I do. I did try one more supplier for a noose replacement and if that doesn’t work I’m probably looking to pick up a new device.

I take it that trying what I suggested yielded nothing?