Penimaster Wrapping Question

Hello all, I just recently purchased a Penimaster, but having a
Little bit of problem

With the comfort band wrap when I put it on should it be
On tight enough so if I hold that and stretch it will not come off or is it the belt tightener thing that does that?

And will the comfort band not work if it looses it’s stickiness?
People talk of a black wrap but I think that might be in an old model, because I only got 3 clear wraps

Should I maybe just make my own wrap and not bother using
The one that comes with the Penimaster?

Thanks:) , any help much appreciated

I’ve been using Johnson & Johnson Hurt Free Tape as a shaft wrap with my Penimaster for probably over a year now. Cut off about a 8 inch piece, pull the shaft out and wrap beginning behind the head working back toward the base. This seems to allow the rubber strap to obtain a better grip and it cuts down on pinching.

After the Penimaster is installed, I take a piece of two-sided Velcro strap and wrap it around (encircle) the end to hold the ends of the rubber strap in place. Otherwise they tend to slowly slip back through the plastic housing, especially after they are used many times.

Aah ok thanks, I thinks thats my problem
I am just trying to put the comfort band straight on the shaft without anything between
The band and the shaft:)

I try some sort of tape or cotton, :)

You can strap it straight on without any wrap. You just have to be careful to pull all skin back and tight so that it is not pulled down into the slot through which you feed the ends of the strap. But using some type of wrap makes it much more comfortable.

Aah ok cool I might give it a try with no wraps next time, and will try some experimenting with

Different wraps too, thanks for your quick help:)

This horribly underated thread may have some tips you can use…

ADS wearing/wrapping tips

Personally I alternative between no wrap, and a small piece of theraband.

Are you cut or uncut by the way?

Ok, I take a look at that thread,

I am uncut so I find it quite a pain to put on the wrap, got to pull the skin back and keep it stretched
Nicely in order to put the wrap on easily, it’s quite a pain:( where should I aim to put the wrap??

A few other things

Should I get a 30-40% erection to make it easier to put the wrap on?
Because I find my willy’s flimsy and hard to get a good wrap around,

On colder days it’s worse once out in the open he turtles from the cold and looses some circulation
Makes putting on the wrap even worse somewhat impossible some day I just give up:(

I’m uncut too, and wearing the PeniMaster at first was a total pain in the ass!

Try only pulling about “half” the foreskin back, then applying the wrap about 0.5” behind the glans (head)

Dont bother getting 30% erection, as after a while one of 2 things will happen, either you will lose that 30% erectin, and the PeniMaster head will fall off, or, you’ll get the blue/cold head effect (not good)

On cold days, try wearing a ThreaP wrap, or just wrap a sock or something around your cock for 30-60 mins before wearing the PeniMaster, this should keep the penis warm, and extended, and therefore make it easier to put the PeniMaster on.

Hope this helps :)

Aah okay, yep that helps a lot, thanks heaps slack and marty

Will make sure I warm up the old twatter before hand,
I will look into first aid sports tapes as a wrap underneath the comfort wrap too:)

Wrapping going ok, but I got a new problem now when I pull the straps down
I feel some pinching which is quite annoying,

Does this just mean I do not have enough wrap?

And another thing, is the Penimaster designed to sit firmly pressed up against your pubic hair region
Or will it just be loosely touching when standing but basically resting when sitting?