Post your penis width.

That’s the attitude :up: :up: :)

You’re getting this 2% number from this thread?

You’re like the girl in that commercial who’s dating a french model she met on the internet, in real life he’s ugly and can’t speak French, but she doesn’t see it, because if it’s on the internet it’s true.

This thread is full of people with 5-5.5” girths posting their dicks are 2” wide or better. Bullshit. Try this, I measured a toilet paper roll at around 1.75” width, times 3.14 around 5.5 girth. Take one, now squash it until it’s 2” wide and look at how short it is.

If you really still believe there’s that many guys running around with pancake dicks, or that it even looks good, I don’t know if anything can help you.

I’m 1.5” across the top, and measure at 5.0” diameter to the mark on both.

I figure the dick-pi is 3.33333, rather than 3.14159. I’ll let the reader figure out what the hell I mean by that, but believing this number nullifies a lot of the bragadashery we see on this thread, and some seem to be downright concoctions.

- Saul

I know that I measure barely 2” across the middle shaft and just behind the glans at the corona ridge. That is a recent development, to boot. So these guys who measured significantly more just must be bigger than me by a large degree. And require no lube for sex. And have zero condom problems. And all have women who have pelvic bones that shift with ease.

I mean we all can do math, Saul. *chuckles*

Today mid shaft I am exactly.
1.77” x 1.50”
Top view x side view respectively.

Measured during calipers.

I ran an ellipse calculator, major vs minor axis to circumference, to compare proportions. In order to avoid fettuccine noodle status, it seems as if a ratio of 3:4 for height vs. width is the limit. 2” width at 5.5” girth has a height of 1.5”, which is pretty reasonable. Now, 5” girth at 2” width has a height of about 1.1” which would be fettuccine noodle status.

Interesting thread, even the fake measurements as well.

Thought I should include circumference/girth.

1.81” x 1.53”
Top view x side view

With 5.2” EG.

Again measured with calipers.

2”

1.875” X 1.625 “

Width 1.95”

Girth 5.9”

Guys,
How do you measure your width????
Can anyone tell me I mean we measure our girth using a measuring tailors tape but how do you measure the width using what???????

Do we use a measuring tape too to measure width or what???

You could use some outside calipers (preferably plastic) to measure the width, which would be more accurate.

Or, like most of us do I guess, lie a rule on the top of your penis, look down from a central position above the ruler, and take your best estimate. :)

I used a ruler but I want calipers. I suspect many numbers would shrink if they were the method of choice here. *chuckles*

[QUOTE=Skygod2016]
You could use some outside calipers (preferably plastic) to measure the width, which would be more accurate.
Or, like most of us do I guess, lie a rule on the top of your penis, look down from a central position above the ruler, and take your best estimate. :)
[/QUOUTE]
Lie a ruler on top meaning place the ruler vertically on my penis shaft????

Is 4 cm wide how much in inch??

Just Google “4cm to inches” and Google will convert it for you.