Crazy idea for a hanger

Sorry this couldn’t go under the hanger section.apparently I’m not privileged enough to post there yet :P I’m somewhat a noob so I guess it’s okay to post this here anyway.

Here’s my idea for a hanger. Someone tell me if I’m a genius or if this idea will fail terribly.

Take a clamp you use for clamping (I use the Cable Cuff clamp) and tie a string w/ a hook on it to attach a weight. That’s it. Like all the other hanging instructions, it’d be important to stretch first, and use some type of cloth wrapped around the penis to prevent any pinching and increase the friction a little. I guess if you make it tight enough, it won’t slip of your penis even with the extra weight added.but like I said, I’ve never tried it. Just a 3am idea I came up with while lying in bed trying to fall asleep.

Thoughts/Comments?

I like it. Sounds inexpensive.

Blessings

That idea has been brought up a few times in the past: Hanging with a clamp?

Sounds dangerous. I’d make it a little more complex: - The Captn’s Wench: PE Device

Simpsons did it!

-I’ve done it, I don’t reccomend it:

You’d have to limit your time to under 10 minutes and even then I wouldn’t say it’s a good idea.

It would basically be a noose style hanger which is a bad thing.

Do check out - The Captn’s Wench: PE Device .

I think you’re a genius ;)

I submitted a similar idea except I built up the insides of the clamp to apply pressure similar to an AFB hanger.

Simple Homemade Clamping Hanger

It didn’t get a lot of positive feedback though.

Thanks for the replies everyone. I want to stay safe so I won’t be trying this haha

There is a good picture of this idea in my thread . Been using it for awhile .

I can’t see it being able to hang much weight.

The reason why the rule exists is because if you spent as much time searching as you did making that great 3D image, you would have seen it has been done before…….

The 3D really is good…….

It doesn’t really matter who starts a thread, if it’s about hanging it belongs in the Hanger’s Forum or in the Review forum :)

Personally I don’t think this will work safely because it’s too narrow and the steps of a cableclamp are too big. You will be hanging from your skin and your glans. You can gain from it but there will be discoloration, pain/discomfort and skinstretching.

Dont let this stop you from coming up with new ideas though.

I’m a little confused as to if you are referring to the 3d model in my thread or not, but I don’t see any links to any other 3d images so I am responding as though it was directed at me.

I had done a fair amount of searching for hanging with a clamp and while I did find the idea mentioned several times before, I had not seen it done with the insides of the clamp built up so it would apply pressure ONLY to the sides of the shaft, unlike the typical use of a clamp that applies pressure around the entire thing, which if weight was hung off it would causing a huge (possibly dangerous) increase in pressure on the rest of the penis.

It was an effort to clarify this difference that prompted me to spend the little time it took to make a 3d model.

As for the steps being too big on the clamp, adding or removing a layer of wrap could easily give you the fine tuning between the large steps of the cable clamp.

I can’t defend the idea any further than that because I haven’t used it other than for a week or two, many months ago.

Whatever you do biologynerd, don’t ever stop trying to innovate. Good luck!