More proof that long periods of hanging may be beneficial?

As I understand it, using tape provides support to the skin to avoid the blister. A condom may have more play and not be as effective as well as the ability for the latex to stretch to accommodate a blister.

With todays vacuum hanging and ability to hang for periods of 60-90minutes with force I would consider multiple sets per day optimal. Historically shorter periods were used due to limitations related to hardware. They are still used today by people who do not have the time for longer sustained hanging periods but I would not consider short high force to be the best way to make gains.

Whats the best hanger will a cheap ebay stretcher work ?

Vac hanger encourages a pe’er, to get more than ten hours , or more a week in, which has been shown, for penises,to increase in length. The people that only have time to hang say 90 minutes a day or ,one hundred twenty minutes a day, each session, the silicon sleeves and all dick hardware, needs to be removed between sets. I did a fifteen minutes heavier weight for me, sixteen pounds, then cooked some food in kitchen. Did not dismantle saber skin, clear glans lock, and chamber, then hung again for twenty minutes. Felt sore. Dismantled ,then had blisters. Been a week and a half ,was compression hanging but possible fulcrum injury, not bad, if any but healing not doing anything. Penis gets beat up from months of hanging, increasing time and ,or weight, progressively, over time.

Short duration sessions, compression more than likely, because vac hangers are not recommend to go over twenty five pounds and some say don’t go over eighteen lbs.

I created my own vac hanging (I actually use a pulley connected to the underside of my desk) using a “cupping” vacuum device as seen here - https://www.ama … /dp/B0C53XG155/

I have the 3.9cm version but there are larger ones. I use the silicone tubing from LG Hanger but there are probably cheaper alternatives (if anyone finds any let me know). I just screwed in a small generic hook into the screw handle of the cupping device similar to what is seen here (where I got the idea) - SiliStretcher-2 All Day Stealth Penis Stretcher | Matters of Size – PPC

Works great and much cheaper than buying a kit. I’ve been stretching about 5-6 hours a day, 5 days a week during work taking a week off each month when I actually have to go into the office. I sometimes pump at the end of the day a few days a week. I’ve been doing this about a month though I’ve been pumping off and on for a bout 6 months but not very consistently. I also use heat/infrared before hanging. I’ve lost some weight in the past few months so it’s hard to tell accurately due to some fat loss in the area but I’ve gained about a 1/2” in BPEL (again some may be to less fat) to be about 6.5” total. I am definitely a grower and 51yo so may be more receptive to hanging gains based on what I’ve read in this thread.

I use about 3lbs currently but will be ramping up soon.

DISCLAIMER. I have no affiliation with any product or service linked above.

Cheap vacuum cup for over 6 years, usually hang 3 hours a day at 10-15 pounds. For 20 and above, short periods I use a cable grip mesh that is omg great, have achieved 40 pounds for comfortable until failure ligs for 20 minutes. No other clamp has achieved the comfort.

I usually hang with an all day sleeve and a 3 pound ball weight magnetic for maintenance. It’s easy to spread it off when I need to piss and re-adjust sleeve and snap back on. Important safety note: Do not jump off any platforms, gravity + acceleration will hurt. Newtons 3rd law do take effect.

What is a "cable grip mesh"?

Phalloson Forte wouldn’t hold 16 lbs. Snapped four , two originals and two replacements.

Stealths vac hanger , tried twice but got blisters and owner doesn’t recommend more than 8 lbs for an hour.

I think it’s best to get the best of both worlds and do compression and vac hanging.

Mesh Grips | Cable Mesh Grips | ElecDirect

Interesting??? Hmmmm

Can you explain ypur setup with the cable grip mesh? Wrap / sleeve??? Size stc. Ty

This is great and just chiming in as similar to what I am doing, just sitting at the desk and hanging straight down currently

Have you increased length past 6.2

For me, I found that a 1.5-2.0 inch size works best. You compress the cable puller ( mesh ) and fit over penis. I use a silicon sleeve as well as glans cap. It basically works like a Chinese finger puzzle. As more weight pulls the tighter it grips. 20 pounds are comfortable with no slippage.

To remove, just push the grip towards your base and slide out.

The mesh sounds very interesting. Could you take some pictures and start a thread about it?

I remember someone suggesting something similar years ago, but it never went anywhere. Some information from someone actually using it would be very useful.

I will, just ordered a newer one that is shorter, so I can sit. Not sure how pictures can be posted here if graphic. It will be here tomorrow, should have a write up by Wednesday.