Vacuum hanging confusion (Page 5)

05-05-2006, 12:49 AM

sparkyx

No matter how hard I tried, the diagram gets screwed up when I post it.

Forget the X’s and the bottom lines should be centered, like the neck of a vitamin bottle.

Happiness begins where selfishness ends!

Physiologic Indicators for Growth (PI's) Force Thresholds

Erectile Quality Thread (EQ) Is Less,More?

05-05-2006, 10:35 AM

mgus

Modesto,

Uncover the vacuum release hole when you take of the Vac-Hanger - then you don’t have to roll the seal all the way back up again.

regards, mgus

Taped onto the dashboard of a car at a junkyard, I once found the following: "Good judgement comes from experience. Experience comes from bad judgement." The car was crashed.

Primary goal: To have an EQ above average (i.e. streetsmart, compassionate about life and happy) Secondary goal: to make an anagram of my signature denoting how I feel about my gains

05-05-2006, 02:44 PM

ModestoMan

I’ll try it, but I don’t think it’ll work. The sleeve is very tight. I’m using a pumpless hanger, so I can’t use a pump to suck my penis into the cap.

Enter your measurements in the PE Database.

05-26-2006, 04:04 PM

LuckyNuts

This device was mentioned on a much older thread about vacuum hanging:

It is a “penis head enlarger”. The opening is 1.25” in diameter, and the inside of the main chamber is 2” in diameter. This gives the “vitamin bottle” shape that seems to be desired. However, you can you a hand pump to create a vacuum for hanging, possibly eliminating the need for a sleeve. Or you could skip the hand pump and still use a sleeve anyway.

My main question is, how would one go about attaching weight to this thing?

Current: 5.5" NBPEL (6" BP) x 5" EG

Goal: 6.5" NBPEL x 5.5" EG

06-06-2006, 03:19 AM

SmileyDog

Anyone know where to get some cheap vacuum hanger sleeves? I have a grip system that works fairly well. They sell sleeves at thegrip.com but they are $7 a piece plus shipping. Also the sleeves start to wear out after only one week. After that I have to keep adding vacuum because the worn out sleeves create a slow leak. I have fixed my grip chamber so that I can use my hand pump with vacuum gauge on it instead of the bulb pump. This way I can tell when I start to lose vacuum, it is very helpful.