Heat = Quickest way to pack a tube.

I just bought a new heat pad today. The pump I got was incredible. My flacid 2 hrs after pumping is still much larger. My girth while flacid is over 5 inches midshaft.

I think this will lead to impressive gains in the near future!

For those of you who want length gains, I don’t think you should be looking to pack the tube. Me, personally, I want girth gains first before length gains. My girlfriend says girth is better. I have this theory that you can achieve length gains relatively quicker if you’ve already packed the tube completely within the first 10 minutes of your session. I think this because once you’ve packed the tube, I think you can go for lower pressures and stretch the tunica and CC’s length-wise better because there is no room to expand laterally.

This is what I’m trying to do:
I want to reach my girth goals first, which is 2” in diameter unpumped erect girth, and then once I can pack a 2” diameter tube within the first 10 minutes of my session, I will go for length gains and kick up the Hg’s a little higher to create more stretching length-wise. Higher Hg’s I believe puts more tension on the ligs, so thus getting length gains also from lig stretching.

I believe for my goals that packing the tube quicker is best for me. I do have a few questions to all of you pumpers and PE’ers in general. Whats the fastest way to have girth gains using combined pumping, manual PE, and other devices? Whats the best way to pump to achieve girth the quickest? What’s the best way to gain girth with just pumping and manual exercises only? I would love to put together an ultimate girth routine that would be available to all sorts of people with different time schedules. Some of us don’t have the time to do ALL PE exercises, some of us have enough time only to do a select few. I personally don’t have a lot of time on my hands to spend on PE, which is why I use a pump and jelq between reps. I can easily do other things while I pump. I was wondering if there are other exercises that I can do between reps, during rests, to help my girth gains and pack the tube quicker. Can anyone help me out here?

People around here are saying that it is better to gain length first and then work on girth. In which case I’d stick with pumping/jelking for now. When your dick is ready, try clamping for more significant girth. Takes a similar amount of time. Just repeating the word on the street.

Back on topic, I had bought one of those cheap heating pads. I took it apart and wrapped the wire around my tube. In my experience, this sucks. It makes it clumsier even though you don’t have to physically hold the pad around the tube for the entire session. Realizing I should still do a warmup first, I bought an infrared lamp at the pet store. I do manual stretches in front of the thing and my dick starts to feel nice and warm. Then I begin pumping and hold the cylinder fairly close to the lamp. I did not expect it to work so well. The heat made it all the way through to my dick and after a five minute session it was still very warm. So I will advocate skipping out on a heat pad and just go with the IR lamp!

Does anyone know if wearing sunglasses will protect my eyesight? I already feel it isn’t good to look anywhere near that light :-)

After just finding this thread recently I decided to try using heat when pumping. I don’t have a heat pad (will have to look into that, in fact can anyone recommend something here in the UK?)

Anyway, I was normally hitting just over 7 inches in the tube. I filled two hot water bottles and basically sandwich the tube between the two. Heats the whole cylinder just fine. To my amazement I reached 7.75 inches! If I continue the routine I reckon I could see me hitting 8 in the near future! Gave me quite a buzz!

So I’m wondering all this expansion and lengthening will have an effect on growth right? If I kept at it say for my intended routine of 5 days on 2 days off how long do you reckon it would take to gain a half inch? Anyone made positive gains by pumping with heat, and if so how long did it take to gain that amount?

Any figures would be an encouragement for all no doubt!

… uploaded a photo of me in the tube here.
pumped and lifecast comparison

This one was taken earlier without using heat.

If you use heat throughout your pumping session, do you still need to warm down afterwards?

Heat improves ALL PE activities. Have not seen the heat pads mentioned here in Australia but ..

Have been using a Hair Dryer. You can pre-heat your cylinder and give it a heat burst whilst pumped

(As required). Another goody is to cover the penis with a warm or moderately hot washcloth and give

It a hot air burst. Just do not overdo it or you will cook your sausage.

I’ll bump this thread in case someone missed it because heated pumping is the way to pump. Using rice sock around the tube I can achieve expansion in 1 hour that would take 2+ hours without heat. It’s amazing. I agree with richard8, heat improves all PE activities and should be a part of everyone’s routine.

Benefits I noticed so far:

- Easier and faster expansion.
- Less discoloration (or none at all).
- Less spotting (burst capillaries) (or none at all).
- Post-session expansion lasts longer.
- Feels nice, warm and cozy.
- No unease or discomfort from pressure of tube against the pubic area.

Only bad thing is having to spread the rice sock evenly around the tube and holding it there in case you don’t have a heat pad that can be simply fastened with some strap or band.

So any views on infrared or normal heat pads. Pros and cons etc?

Yes, there are grounds for this you are saying.
Try to get a sock to put rice in the microwave and heat.
Place the sock inside the tube and leave for 5 minutes.

I do it sometimes when I do not have much time. It is an alternative.

I too have been pumping with a heat pad consistently since April thanks to Titliest’s advice about using heat, I thought it was common sense to buy an electric heat pad, they are almost custom built to wrap around tue tube! And yes, I have seen results from this, nothing out of this world, but definite measurable and significant results for the length of time I’ve been pumping.

Where can one buy a electrical heat pad? Would Walmart have one?

Been pumping with a heat pad for years.

The best heat pad I have found is the Thermipaq.
It is clay not gel or liquid, so it does not degenerate or loose it’s substance. You may never have to buy another heat pad again.
It heats in the microwave in a minute or less and stays warm for a long time.
It measures 9 x 6 in. So it will cover most of your pumped length evenly.
It also has a velcro strap so it will hold itself around the tube.
I found it at CVS for about $12 - $15.

I just added a heating pad to my routine with the CTC 4000 pump. Feels great while pumping.

Yup. Been using one myself for years. Keeps things pink and makes for quick progress, though I don’t know how permanent it is. Sure is more fun, though.