Homemade Tubes?

Which product are you using for this dip skeebo?

The dip is used on hand tools. It’s very volatile stuff.

No seal is going to work if you have hair though. It has to be removed constantly and it’s a real pain!

It would have been nice if that part of me would have just stayed hairless all except for a little postage stamp. :)

I have hair and no problem with a seal being kept at all, I’m interested in which product skeebo is using though.

This is what I use:

Plasti Dip 14.5 oz. Black Plastic Dip 11603-6 - The Home Depot

Got the last one at my local home depot when I got my most recent cylinder. I applied four layers to the base of the cylinder and it works perfectly for me. I am also one that has not experienced any issues with hair. It works just as well with our without all the pubic hair for me.

Good one skeebo. :up:

Made mine out of a drinks cup.

The top unscrews leaving a factory smooth edge that won’t dig into the fat pad.

I drilled a hole in the top with a bit slightly smaller than the tube diameter, worked the tubing into the hole about a half inch, the device works perfectly for mouth pressure pumping.

The pump cylinder is 8” long and the base diameter is 2” and so stretches me out nicely for length and fattens girth slightly as well.

Nice thinking. Looks solid.

Two question spring to mind. Did you test it for size before deciding to use it? If it hadn’t have fitted would you have put it back in the cupboard for later use in it’s original capacity?

I would epoxy the hole first before putting it back in the cupboard!

Actually I found it at a thrift shop and thought it would be an interesting experiment.

:)

Good find then. You find strange and great things in thrift and charity shops.

Home made flexible tube idea. I have a plastic tube with a lid on it. It is made of stiff but thin clear plastic. I could attach a hose to the cap. I have the trimmed off silicone piece from a worthless cock extension. This makes a good seal at the base. I was thinking that this could work. As I draw a vacuum, the sleeve will flex into an elliptical shape, more or less following the shape of my dick. As my dick swells, it will eventually pack the cylinder. Could this work?

Test the air seal by blowing in the open end or slowly submersing it in water and listening for leaks. If it doesn’t work for air, it might still work for water as it has bigger molecules. Easy to test again.

It’s useful if you can see through a cylinder to monitor your penis. It’s also useful if it’s the right size for your penis (Selecting Your Cylinder Size).

I get 90% of my clothes at value village.

Hugo Boss, Zegna, Guess, Ted Baker.

Amazing!

I used my new pump in the bath yesterday after sealing the tube with 2 part epoxy.

The pressure difference was profound, and after 15 minutes my dick was a swelled 7 1/2” purple sausage.

No functional damage though. So hard this morning I thought the skin would tear.

I can’t wait to see what the next few weeks will bring.

Struggling with flu symptoms otherwise I would have used the pump again today.

Incredible inflation and stretch.

A week later and having 110% erections and expansion in the tube is amazing

The opening to the tube is only 5 1/2” so it seals quickly, but with full expansion I’m worried I might get stuck, but with mouth suction the pressure release is instant, so no dramas yet.