Vacuum Pumping 101

Doh! Great idea. I never thought of partially filling the cylinder.

tnx man.. sounds interesting!.. I’m gonna try that pumproutine 5 min drop to 1” then pump up to level.. and repeat.

How long did you do this 5/5 split routine, and was it safe whitout donut and all that, and was your EQ good after session?

Tnx

I have a full package pump. I want to try water pumping, but the two times I tried it I just made a mess. Either getting water all over, in the pump line, or both. Anyone with advice on that?

I like water pumping in the hot tub. Relaxing, automatic heat source and no mess issue. Bathtub could work as well.

Pump with a water/vacum reservoir. have to take a pic from my gear. Its like brake line bleeding kit.

So the only issue with using a regular pump as a water pump is the concern for water coming in the gauge?
I bought a digital one (look link below), and when you look inside down the tube, there 1 small hole approximately 4-5mm in diameter and through it I can see circuit and a small chip.

If I could plug the hole with something there I could use it as water pump then?

I don’t have a full package pump, but I decided to try indoor water pumping using cylinder space as a reservoir. In my case, I have at least an extra inch of tube space left after full pumped expansion, and I found that careful manipulation of water levels allowed mess-free water pumping.

With the pump disconnected, add some water to the tube. (This will be a trial-and error process, so start with an amount of water you are confident will be too small.) With the cylinder pointing generally downward, insert your unit and firmly press tube until you have a good seal. Maintaining firm pressure on the tube, you should then be able to lie down without spilling. With the tube pointing straight up - and a fair amount of your cock above the water line, you can then attach the pump line and begin applying vacuum pressure. If your dick is not fully immersed at the desired pressure, depressurize the tube, add a little more water, and try again. (Once you find the right water level, you may want to mark the cylinder for future reference.) You can vary the pressure on your fully immersed unit, as long as you keep an eye on the water level to make sure it doesn’t enter the pump line (unless you have a small additional reservoir attached).

Could be my imagination, but I think I got a little less length expansion this way compared to air pumping.

NOTE: This method is obviously not going to work for any one who packs the tube length-wise. But for guys who want to try mess-free water pumping outside the hot tub/bathroom, this might be an up-side of deliberately getting a tube a couple inches longer than your minimum requirement.

How would you guys rate LeLuv Pro Bigger Penis Pump? The price at $62 is within my budget

Is the penis pump LeLuv Pro Bigger Penis Pump a good choice? The cost is within my budget $62

You could make this easier by giving us a link, but here goes. It will make a good beginners pump, but you should get the model with a gauge so you know what you are doing pressure wise. Also select your cylinder size using our size chart: Selecting Your Cylinder Size

I have a kaplan pump and had recently heard of the Leluv pumps and I must say that for the price they are outstanding set ups. They have a nice flange and are made of the same materials that the higher dollar pumps are made of. The pump/gauge set up is made of brass and is of much higher quality than I got with my set.

I am going to buy one soon. I am into hanging as of now but I want one for my future girth gains and I am not sure if they will keep the prices where they are at in the future. I was blown away but what you get and I think the set up I was looking at was around 70 to 75 bucks. If you wish to PM me I will give you the site as I do not know if you seen them on E-bay as I ad originally found them there. Off the subject of pumps, they had all kinds of other stuff so I blew about 70 bucks on toys for me and the wife and I know I got about 150 dollars worth of stuff.

Been pumping seriously now for a few months.
Routine:
100 jelqs
Pump for 10 minutes
Another 100 jelqs
Pump for 30 minutes

I have found my penis responds much better, I maintain an erection, if I pause after the first 10 minutes and start pumping again after a few jelqs. During the 30 minute pump session though I find it nearly impossible to maintain an erection inside the tube, I can feel it go away even though the size doesn’t change in the pump. The weird thing is as my erection disappears I begin to fill the pump a lot more. Is it normal to fill more of the pump when not erect? Do you think its a good sign I am filling more of the tube even though I am not erect? Maybe I should change my routine to always pausing every 10 minutes to jelq? After coming out of the tube hard the first time I almost never seem to be able to get back to a 10 out 10 EQ erection. Any comments about my routine or what I have noticed would be appreciated. Thanks in advance.

Just received my 2x10 pump from Penis Depot with metal gauged pump. The hose end (part that looks like it’s supposed to attach to something) doesn’t “click” nor screw into cylinder—as if the cylinder hole was too big for the end part.

I tried it and it can only hold an extremely small amount of vacuum if I luckily hold it a certain way. Did I get a dud or am I missing something?

I can make a video if needed to show what I’m talking a about.

It sounds like they forgot to screw the female quick disconnect coupler into the end of the cylinder. Don’t need a video, just attach a pic of the cylinder and hose end.

Edit: Here is a pic of the cylinder with the female coupler and hose end with the male coupler. Do you have all of these parts?

Yep. I just found it in the box. I have everything I need now. Thanks.