Finding xeno: a penis tale

On Xeno’s use of his TUNICA TENDERIZER:

I did not see Xeno state at what percentage of an erection he used/applied his tunica tenderizer. I would assume he got as good an erection as possible and worked his dick over “squishing” the fire out of it to stretch his tunica, probably going around his dick at quarter circle stops or less to stretch the tunica and applying pressure.

This seem rather torturous to me and not too distant from the suggestion I saw once to take a rolling pin to your erect dick layed up on a counter and smash the dickens out of it for girth gains.

Anyone out there who can fill us in on what Xeno’s method was with his tunica tenderizer? Thanks.

That’s a good observation, it was when he began the tunica tenderizer and sumo stretches, among the other parts of his routine of course. Could be worth re-reading 2016 from this thread.

Looks like it is still working and he is now nearly 10x7.

He did. There is a photo thread in his signature, demonstrating some of the most intense clamping methods known to man.

He was taking the photo with one hand.

Okeedokee, here you go:

Green: 26mm
Blue: 25mm
Red: 25mm
Yellow: 18mm

Note that measurements for Blue and Green were done from the top line datum and measurements for Red and Yellow were done from the middle line datum; the lowest line datum was not used.

A couple of additional points:

The front bottom bolt will need to be bent (as close to the left inside face of the BIB, when positioned relative to your body in the way that it would be used) in order to facilitate the front splayed geometry.

A nut is used against right inside face of the BIB to hold that front splayed geometry open.

The receiving channel for the top bolt will need to be dremeled somewhat in order to receive the top closure bolt with the new front splayed geometry; in essence what this means is the surface of the “long” tooth on the top right, the one that bounds the receiving channel on your body’s side, will need to be ground down along it’s outer (away from your body) face in order for the bolt to clear it when dropping into the receiving channel.

And oh yea, yes, the bottom teeth do need to be sanded down…at least the front (away from your body) edge of the right rear tooth, in order to allow tight closure at the rear of the BIB…I think that the bottom photo of my BIB shows this well. I also sanded down the front edge of the left rear and a little bit of the second from the right rear tooth. I recommend sanding down the top teeth and then sanding down the bottom teeth to allow tight closure at the top AND bottom…then you’re done.

I hope that this makes sense; please let me know if not.

And thank you for your patience and persistence Jack; two attributes that I much admire, and which portend very good gains for you :)

Best,

xeno