Ball zinger - new great (but difficult) idea for boosting voltage
I was playing around the other day, and discovered that if you replace the air in the ball zinger with saline solution, the voltage produced jumps from ~.12 volts to ~.80. Yow!
Whether this is a good thing or not I have yet to know. When I did finally get the .8V water-filled unit on (the problem, below) I immediately went to a VERY large flaccid state pushing toward erection. I don’t know if that’s in my head or what.
Problem: if you just fill the tube and push it on, it doesn’t stay attached (presumably because of the lubrication from the water). I tried drying the tube end with denatured alcohol, but that didn’t work…perhaps had I given it more time; I’ll try that with fresh latex hose.
Then I tried injecting saline solution throught the hose with a medical syringe, which worked well (also sucking out the air), but that leaves holes in the tube, which dribble when the latex is stretched.
One more idea is to inject solution right next to the rod or tube, then push the tube further so the hole is covered by the metal contact. I’ll try that when I resupply with latex hose.
And other ideas?