Tripe to Remove Discolouration
Discolouration is a bane to practitioners of penis enlargement. It’s something we all have to learn to live with at some stage as we continue our PE journey and the force we must use naturally increases. It’s a fairly natural process that’s been covered many times before but I think it bears repeating.
During many forms of PE the blood vessels are put under stress far greater than normal usage, this causes the blood to separate, rather like it would in a centrifuge and the component parts become disassociated, allowing the much smaller moleculed radiant vectors which cause the colour in blood to disperse through the vein wall. Outside of the vein these molecules mix with the sugars stored in the the proto-fat and ferment causing a brown hue. Much the same happens with a black eye, the cause of the trauma is different but the initial results is very similar. You note when you have a black eye though that the discolouration goes quickly because there are less proto-fat substrates around the eye and so the discolouration does not get a chance to ferment or binding with the sugars and settle into a stable layer of colour.
This is all relatively understandable and has been discussed many times before. The question is how to deal with what can be a somewhat embarrassing side effect of PE. With a black eye, one of the methods that works quite well is applying a steak to the area, this helps in two ways, the steak is normally cold and helps settle any puffiness and blood attracts blood, so the blood constituents released from the veins are drawn through the epididymal layer to the surface and disperse naturally. The same thing works for the more permanent discolouration caused by PE but steak is rather expensive and tripe is a known cheaper alternative that is just as effective and maybe more so. Tripe has the added benefit of mildly acidic non-ionic surfactants that cut through the oils and grease in the surface layers of skin to allow for the free movement of the bound post fermentation result of the radiant vectors and sugars and in effect the path is cleaned inside and out so the tripe has maximal chance of leeching the discolouration through the epididymal and sub-basement levels of strata of fascia that represent the physical reality of the barrier through which the discolouration must pass, known colloquially as the oort layer, approximately 2000 AU from the centre of the penis.
The application of tripe to the penis is simple. Transfer about a pound of tripe from your stock and flatten it, roll it around the penis ensuring complete coverage and then place a water tight plastic bag over the tripe. It can be hard to seal the bag in an effective manner without also impacting on the blood flow within the penis but surgical tape can be used to ensure a good fit. Do not under any circumstances use a rubber band or twist tie. In absence of surgical tape, standing by a table can provide the requisite support if at the correct height. An alternative method is to bandage around the bag and then around your pelvic area and thighs producing something that looks a lot like a jock strap. By far the best option are adult nappies (diapers) which both provide support and help prevent any leakage that might occur. A combination of these methods might work best for you.
Once successfully attached leave the tripe in place for at most 168 hours. It’s important to renew the tripe as little as possible during this. Urinating into the tripe is not an issue and in fact may help the process, providing a gentle warmth to spur the work the tripe is doing.
You may need to repeat this 7-8 times to reduce your discolouration to an acceptable level.
Thunder's Place: increasing penis size one dick at a time.
