vacu-hanger

Just got the vacu-hanger! It works great very comfortable, the only thing is I caused myself some water blisters from take the damn thing off. Anyone have advice on how to take it off without it feeling like ur ripping ur penis out of a small hole. I do fold it all the way back or as far as i can. Let me know thanks!!

“ur”?

Where did you get it?

shorthand for “you are”

Shorthand is obsolete. :spam:

haha sorry for the shorthand. I need a break from writing correctly since thats all I do in college ugh! Anyway I just got my vacu-hanger from, Autoextender Penis Enlargement Device

See my thread ‘best way of hanging - some ideas’, especially wrap-tips. Also, when you remove the sheet, but the weights just a 10th of an inch above the floor so when you bull the sheet off it won’t fall and stretch your skin execcively.

Good luck
Ticker

Thanks

thanks ticker, one question about the tape, do you wrap the entire head/glans and make sure the skin does not bunch up. Cause the problem I have with the vacu-hanger after 5 pounds is that the construction sleeve on my penis head slips off, and without it my skin gets bunched up and forms blisters.

I bull back all skin first and wrap then, so that all of the dick which goes in the tube is covered and that it fits tightly in the tube, all the way to the end. Then I pull the silicon tube over, and apply the vacuum while slowly increasing the weight.

You do roll away the seal from vacuum release hole when you take it off, don’t you?

ha, yes I do.

Mgus - I just make a tiny opening to let the air slowly in at first, then unroll

Hey UhOh,

Take Thunder’s hint.

See if you can follow the forum guidelines here. That means no chat-speak shorthand, as well as capitalizing the beginings of your sentences and proper nouns, and punctuating properly, etc.

If you make good writing practices second nature college will be easier. :)

As far as your question, mgus makes a good point. You should be able to break the vacuum seal so that taking the device off is very easy. rather than pulling it off against the vacuum, which would undoubtably be rough on you. That seems to me to be inviting injury.

If you break the seal it should just slide off.

Good luck.

Just curious

Where can I buy a GOOD Vac hanger ?