Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Some New Questions

12

Some New Questions

First off I have got to say that I wish I had been pumping from the beginning of my pe career.

Then maybe I would’ve been more consistant. I’m fucking loving this.

I pump slowly for gain reasons, I pump a little more if I know the woman is coming over, to plug her full. And she is all about it too!

Ok here is my questions and statements.

I purchased the 1 1/2 x 9 and a 2 x 9 to go with my 1 3/4 x 9.

I start small and work up.

Is it better to jelq between each set or after the pumping routine is over.

Or does it matter as long as you jelq for extra bonus and gains.

Also I start at 6 x 5.

Then end around 6 1/2 or 6 3/4 x 6 when finished. (depending if I did length exercises as well)

So if I want to concentrate on length pumping, should I only do the

1 1/2 x 9 cylinder only, with a couple days here and there of the combination. Or does it matter, because I am going to be getting all of it worked out anyways.Therefore taking whatever gains just come my way.

Ofcourse any gains are good gains, but I dont want my girth passing my length.

Girth seems to be easier for me than length, which is why I am concerned.

I am in my 3rd month of pumping, with other exercises added in.

And I know I started just below 6” in length. And about 4 3/4” girth.

Now I hold a steady 6x5. Which is fine with me. Hoping by summer to hold

steady 6 1/2 x 5.? and pumped to 7 x 6.

New Years ‘07 I am hoping a steady 7 x 5 1/2 and pump that puppy to

7 1/2 x 6 1/2 which is my goal. And then from that point on just maintenance to cement it, however long that takes.

I can give you my opinion on one of your questions…

Originally Posted by pocopeepee
Is it better to jelq between each set or after the pumping routine is over?

Back when I pumped (it has been awhile), I always jelqed in between pumping sets for 2-4 minutes. Furthermore, I always began my PE routine — before pumping and jelqing — with a manual stretch (after warming up).

If you are interested, here is the routine I followed


My Before and After pics -- .5" gain...

For most guys, using vacuums above 5 in hg is not a good idea.

Jelquing is good to apply momentary internal forces that exceed that generated by 5 in hg…allowing greater tissue stretch, which the vacuum then maintains or even expands slightly.

Most guys jelque between sets, which make sense.

As Blop says, I think modest manual stretches before can be helpful.

Very good info.

Thanks.

I dont really go over 5 hg, unless I have been in the tube a while.

Then I do 6 and maybe 7 if it feels comfortable. But not everyday or all the time.I dont want blisters.

Although out of curiosity I did do a steady 7 hg for an hour once, with a break every fifteen minutes. Just to see how big i could get at this stage.

I was impressed.

The biggest I’ve ever been in my whole life.

Now I dont do that everyday, just wanted to see what it was like once.

As far as jelqing goes, I was just doing it once after the whole exercise routine.But it does make sense to do it after each one.So I’ll try it that way.

Can anyone answer the part about just using the 1 1/2 x 9” tube for just length. Or will I gain length anyways by using all 3.

Like I said , I dont mind gaining both i just dont want my girth to pass my length. So if it is wise just to pump for length a while and jelq and stretch.

And then start up the other two tubes later, then let me know.

Also about the heating pad. Do you just wrap the tube while your in it?

Or are you saying warm it up and then use it after its nice and toasty.

And what are the benefits of this? I’ve read about this before but dont quite understand the full concept.

If you want primarily length then use the 1 1/2” tube until you get the length you want, then go for girth.

I am in the camp of going for length first, then go for girth. Not everyone agrees with this though.

I have to say, I think pumping is an exception to the rule, because you use the same forces for girth as length, and don’t use the super high forces like clamping…which in my opinion…can easily toughen the tissues to the point that lengthening becomes difficult.

Heating pad can be wrapped around the tube to keep you unit heated thoughout the process, which is usually benficial.

Hey guys, whats up with the rule that 10 hg is too high? I go up to 15 and feels great. Going for 5 hg, honestly I don’t feel anything. 10+, not higher then 15, is what seems to work. Is anyone out there like me? Or does everyone use small pressure. I’ve been pumping for only 3 weeks. Prior to that I used the stretcher extender, and did some jelqing so I toughened my dick to use such pressure I think. Reply and give me your opinions, thanks.

Hey AlphaD,
welcome to the forum! :) (You have been here 4 months actually, maybe “welcome from out of lurk-mode” is more fitting?)

Listen, everyone is different, but experience and anecdotes gives us a consensus, for most people, best results are achieved through low to moderate pressure.

With 3 billion men on the planet, I am sure a few could have no untoward effect using 15hg after only a couple weeks of pumping. But there are many examples of people being too eager — too much pressure too soon — and suffering at some point down the line, if not immediately.

For most PE exersizes, “slow and steady wins the race”.

Are you sure your guage is working correctly? (Mind you, I don’t know how to test one…)


My Before and After pics -- .5" gain...

What does hg stand for and is it a way to convert it to PSI “pounds for square inch”

Thanks

InHg is the abbreviation of inches of mercury at 0 C/32 F degree. 1,0 PSI = 2,0360 InHg.


Starting Stats (February, 2006): 6” NBPEL, 5” EG Mid-Shaft; Current: 6 ⅝” NBPEL, 5 ½” EG Mid-Shaft; Goal: 8x6” NBP.

Originally Posted by NelsonNelson
What does hg stand for and is it a way to convert it to PSI “pounds for square inch”

Thanks

For every inch of Hg figure about .49 lbs. So if your pumping 5Hg that would equal about 2.5 lbs per sq. inch.

This is probably a useless piece of information to most people, but measuring vacuum with mercury is about how high vacuum can lift liquid mercury up a vertical tube. 10Hg would mean the vacuum level applied to the tube would lift the mercury up 10” high.

Just think, the next sexy babe you meet you can impress her with this information and she will swoon all over you!!

Originally Posted by Tsuga
For every inch of Hg figure about .49 lbs. So if your pumping 5Hg that would equal about 2.5 lbs per sq. Inch.

This is probably a useless piece of information to most people, but measuring vacuum with mercury is about how high vacuum can lift liquid mercury up a vertical tube. 10Hg would mean the vacuum level applied to the tube would lift the mercury up 10” high.

Just think, the next sexy babe you meet you can impress her with this information and she will swoon all over you!!

I could also show her my 7.5 inch around “circumference” penis and really impress her and she would swoon all over me.

Yes, I got my pump from Dr. Joe Kaplan’s site. Seems to work great. Thanks for the response. And sorry if it takes long for me to post. And I wish to all the pumpers to achieve results. Good luck.

Originally Posted by NelsonNelson
I could also show her my 7.5 inch around “circumference” penis and really impress her and she would swoon all over me.

More like scream and pass out!

How do I look in my avatar
yea that is me ugly ain’t I

that is funny my spell checker didn’t go off when I typed ain’t
and my teacher once said Ain’t ain’t a word.

Top
12
Similar Threads 
ThreadStarterForumRepliesLast Post
Read - The Second PE Survey -- A Thunder's Place group projectremekPenis Enlargement32706-02-2017 01:29 AM
My year end report plus a lot of questionsLJ001Penis Enlargement612-20-2005 03:52 AM
Another new guy with new questionsbonercatPenis Enlargement Basics801-12-2005 03:14 PM

All times are GMT. The time now is 01:17 PM.