Avocet8,
Thought I would post my routine to get your inputs and recommendations.
I plan to combine the following elements: 1) Heat; 2) Penis Stretcher; 3) Light massage; 4) Pumping; 5) Magnetic Wrist Strap; 6) PC flexes as follows -
Early in the morning - light massage, put on the stretcher, then put on my special ‘rice’ sock preheated >115 deg F and hold for 30 minutes while my heating pad warms my pumping tube up. After warmup, remove the stretcher and massage to erection - prewrap the c-scar with therawrap and lube up for a pumping set.
Since I am just starting pumping I am at 4 inch Hg for 10 minutes, following your program guidelines. I do 100-200 PC flexes while in the vacuum tube. No problems with fluid engorgement so far and I am packing about 15% of the tube at the base. Started with an erect girth of 5.2 inch, using a 1.75 inch ID tube.
After pumping, back into the stretcher with the heated sock for an hour.
Continue stretching with breaks every 45 minutes to an hour. Gradually back of on the heated sock at midday. Continue with the stretcher until I get 8-9 hours cumulative time in the stretcher. Perform PC flexes distributed throughout the day - right now I do about 400 flexes total. Finish up with a light massage and then wrap with the magnetic strap for the evening.
When I get to the twice-a-day sessions on the pump, I plan to finish the day with a pump set followed by the magnetic wrap.
My goals are initially to stay with the 1.75” Tube and work for length. I started at 5.9BPEL and right now I am at 6.3BPEL based on gains made with the stretcher, heat, and PC flexes. Having gone through the breakin period on the stretcher, I started pumping two days ago. The general idea is to use internal forces triggered by pumping to balloon the penis at very modest levels of vacuum and then use heated stretching to ‘seal in’ whatever gains I get. I am in no big rush - easy does it. Once I get to my length goal of 8-BPEL, then I will go up in tube diameter and work on girth. However, if I get girth and grow out of the 1.75 tube, I will have to step up to the 2.0 tube, like it or not :-)
I appreciate all the care and attention you have given both to this thread and collectively to the forum.
Looking forward to you response,
MrTiPS