Balls are going into Bathmate!

So this is kinda embarrasing but my balls are kinda close to my shaft and they don’t hang down. I also suffer from Turkey neck. And everytime I use the Bathmate, one of my balls get suckered into the tube when i start pumping. Has anyone had this sort of problem and are there are any advice on how to fix this?

Balls keep getting sucked into cylinder! Please Help! Future of pumping at stake!

You should run hot water over your balls until they hang better (that’s if you haven’t already).
I know exactly what you mean, I have almost done this myself. I use mostly in the shower now because the bath takes to much time. What I do is, once I manage to get my dick into the tube I push back ever so slightly to make sure no water runs out, then I take my ball sack and gently wiggle it down making sure there is a small space between the tube and the closest ball.

Just mess around with it mate, it took me nearly a week to find my sweet spot.

KT,

Shilby is right. Make sure you warm up and it helps to positions so that there is more space above your penis in the tube than below so there is less room for your balls to get sucked in. You may need to do a little shaving to make sure you get a good seal higher up on your abdomen.

Like the Walrus said “there’s nothing like a tight Seal”.

I think they offer a bathmate that has only 1.88” diameter, whereas the regular one is 2.56” diameter. Getting the smaller one will ensure your balls stay outside. But make sure your girth is less than 5.9 (1.88 x 3.14), otherwise the smaller one won’t fit over your dick I think.

Well, some guys swear by “Full Package Pumping” so maybe it is not the end of the world?

Has anyone gained with the bathmate yet?

I have just began week 2 pumping everyday. I think I have gained a tiny bit judging by the feel in my hand, I could be wrong but I might have gained 0.1”

I used the pump last night and had sex straight away, damm it felt good. I must have been .25”/0.3” bigger, it felt awesome in my hand.

I take it if I haven’t had any morning wood for a while now that I must be over doing it in the bathmate?
I woke up to my gf giving me a blow job before work this morning and I noticed I was rather soft and floppy. EQ was probably 5-6. Seeing how hormone levels are higher in the morning I should in fact have a ragging boner but this one was a bit pathetic. Too tired to care or worry at that time but I must be over doing it.

When I first got my bathmate I was too impatient and tried to get as much expansion as possible, I was shooting for 18.5cm, even though at 16cm seemed perfectly comfy, but I was after fast gains, which, is a no no as we all know. This affected my EQ. After discovering that I had jumped the gun too much I decided to drop back down to the 16-17 mark as that is where it feels most comfortable.

One thing I did notice was when I was in the bathmate last night when I was around the 16cm mark that it hurt quite alot, which was odd as I only felt pain when I was above 18, it was the kind of feeling that I have when I have far too much sex or jacking off.

It seems that I am going backwards in my pump :S I don’t know whats up with my john-stone. But I have a hunch that because I over did it for the first few weeks, and then dropped the pressure a lot (1.5cm), my over worked penis never actually healed/recovered properly within the that period and was continuing my routine without noticing.

Basically. I think I over worked my penis too much and didn’t take any days off for it to fully recover, then thinking if I dropped the pressure surely it would fix it.

I think I need a day off to fully recover.

I hope this post makes sense, as I’m getting lost reading it back to me :S

Can someone just agree with me to put my mind at rest. Does it sound like I need a days break, or two, or a week?

Yes, take more time off or back down on the vacuum level.

Thanks sparkyx.

Because I love pumping so much I might just take it down another cm until Monday comes.

I think that should sort out

If that doesn’t do it, keep dropping it until EQ begins to climb again. Once EQ is back to normal, you can slowly raise vacuum until you find the best level. Keep in mind there may be a couple days delay when you begin to over train until is shows up…so go slow.

Actually Sparkyx

I think I will take a week off. My EQ seems to be a bit shit just now. I think I over did it for a few weeks with out paying attention.

When you start back, use a pumping level where you only pump until your dick is at 1 inch less than your bpfsl (bone pressed flaccid stretched length). If after a week or so, your EQ is still good, then slowly increase that by about 1/8 -1/16th of an inch a week.

Monitor your EQ during this time and note what happens with your length in the Bathmate, in relation to your bpfsl. You will find an ideal range for you.

For example, maybe 1/2 inch less than your bpfsl gives you great results, and great EQ. Maybe when you cut it to 1/4 inch less than your bpfsl, your EQ starts to go in the toilet.

Now you will know that 1/2 inch less than your bpfsl is what works best for you. So, you will measure your bpfsl each time before you use your Bathmate and have a very good idea how much vacuum to use.

As your bpfsl increases, so will the length you pump to while in the tube, because the length to which you pump to in the tube will be based on bpfsl, so as that length increases, you will increase it by that much when you pump.

Remember for many guys, the difference between gaining and crashing with pumping may be 1 in hg. With the Bathmate, you don’t have a gauge, so you have to use length instead.

Thanks again sparkyx

I have a small question that I had been thinking about the past few days. For eg. If my EL is 7” and I only pump up to 6.5”, will the remaining 0.5” increase or get a workout even though you cannot see it? If you catch my drift.

This morning I woke up with morning wood after taking 2 days off. I think I will wait until the end of the week before I start up again.