MM,
I think there are a few key missing points here that I would have loved Xeno to answer, but he felt like we all took to long to come around…
Anyway, I think the 2 weeks is about right growth before it dramatically slows, but the real question is…what is the starting point?
If you aren’t GETTING growth, then the 2 week period is really a useless cutoff point.
He had first found the amount of wt and time that was working for him, THEN found the optimum progression of time and was able to chart when it dramatically slowed down.
So, the real trick is you have to FIRST find a force/time and mode that is getting progress for you, then you can begin to experiment with the IPR thing.
The other question I had for him (which he wouldn’t answer, because I had asked too late) was, how do you determine when decon is completed?
That’s pretty critical in my opinion, and I have yet to find a satisfactory answer.
I would also like to know how he determined the length of time for the P phase, and what are the objective signs.
I doubt he is ever going to come back and answer these questions, so we are left to our own resources…which aren’t too bad.
We have had a bunch of our guys that achieved similar growth in comparable times. Monty is one of those…and his approach had many similar features. As a matter of fact most of those who had good gains had many similar features in their workouts. In distilling those common features, we can get some very good guidance.
One of the things I find interesting is most guys growth slows greatly or stops at about 2 inches length gains…some go past, but damn few. I think those that go beyond should be studied closely.
My conclusions are that the 2 week time frame is a reasonable one, and should only be extended if your growth is continuing at the same rate at the end of that period…but you should be ready to shut ‘er down when it slows or stops.
I personally think that when you combine this approach (in its general form) with the PI approach, you have a pretty good blueprint for sustained gains, its just a matter of finding that initial growth starting point. I think that can be best achieved by starting at a very low force/time baseline, and slowly ramping up until gains start.
I think hardgainers should start ridiculously low force/time levels, and of course, PIs should be watched very carefully to make sure you aren’t overtraining.
With this approach, it may take time to find the growth point, but you WILL find it.
I think a lot of guys get into way overtraining immediately, and then never “reset” their tissues with a decon break, so find it almost impossible to find the level that works for them.
I think that if you have been experimenting with high force levels, and nothing is working, its critical to take a month or two off, then start with very minimal levels and slowly ramp up while watching PIs.
If low force/time levels are what will work for you, yet you have caused major tissue toughening from high force/time…you could drop down to the optimum force/time levels and get no results because you tissues are still toughened from the high forces used previously.
To me this explains why a lot of guys can’t seem to get any success. They usually end up increasing their forces to the point of injury, not aware that they long passed by their proper force/time levels.
If they drop down to the proper levels, it won’t work either, until they take a long decon break to let their tissues reverse some of the toughening.
How many times have we heard stories of guys that end up with huge force/time levels…get hurt, then after finally recovered, start with a gentle newbie routine, start to get gains, then ramp it all up and everything comes to a shreeching halt! Or, get smarter and find they get much better results with much less.