Homemade Power JELQ

That was a cool thread, but I really think that someone could make something like this it’s a pretty simple mechanical device as far as devices go. It’s just up down release and tighten it would be the most advanced PE product out there but with all the f-ing engineers and garage inventors we have someone should be able to make this and sell it for under 200 bucks.

Okay, then we now have the Dino Challenge. First person to invent this…

…will receive…I don’t know. Something. A hearty pat on the back.

Ideally, the materials could be found at a store or purchased through the mail. The total cost should not exceed $200. Assembly should be possible by a guy with basic mechanical ability with tools found around the house or readily available.

If this gets much response I’ll split it out as a separate thread.

I always pictured something along the lines of those towel wringerouters at the carwash.

The wrap on the plastic rollers should be only on the sides. This puts more pressure on the CC and less on the dorsal nerve. Not only is this method of wrapping much safer, it is 10 times more effective. When I was jelqing with it the other way, I noticed the Dorsal veins were being pulled off to the side quite hard. Now with the wrapping only on the sides, the dorsal veins stay in place and it’s much more comfortable.

Also be sure to wrap the sides as big as can possibly fit in the foam padding. This way it gives you a good separation from the sides and the middle.

I finally managed to get some of the original jar lifters here in Germany - I ordered them at eBay.com and payed with Paypal.

The jar lifter did arrive today and looks very promising. But I have one question:
The 2 rolls nearly don’t roll at all… They are very hard to move by hand and I could imagine that
it would only pull the skin if used in this state.

Did you modify the rolls? I thought about enlarging the holes on each side.
The best idea would be to cut an aluminum cylinder to the size and make a hole through the center.

JJ

You really dont want it to roll. Use it with dry jelqing method in mind.

I have to say, I’ve been using my PJ for a few weeks now. I seriously doubt I go back to using my hands. Not only do I get a better workout with the PJ, it’s much easier on you’re hands, and you’re skin as well.

I’m not sure how others use these things, but I used mine positioned so the rollers (that don’t roll) were on the sides of my shaft. Sliding over and compressing all the goodies on the dorsal side (top) of the penis felt uncomfortable and seemed like a bad idea.

Really, you do it from the side? I havent tried that yet… I remedied the dorsal veins by only taping the edges of the rollers. This gives me a padded middle, and the sides (CC) get squeezed down before the middle is fully engaged.

Providing a groove there sounds like a good idea. I haven’t tried it.

It is harder to do it sideways, but it is a much better exercise.

I agree totally.

I did it sideways last night, and it was great. At first I was thinking this isnt going to work, my dick kept shifting and turing to one side or the other, it seemed impossible to balance it. But simply holding the head with my free hand held it in place nicely. With the rollers on the sides I could jelq much harder without any fear of pinching a vein.

However I think my tape method has merit. It just hasnt been perfected, and a solution might be in using a bigger pad, and tape the sides up more so there is a larger channel for you’re dosal veins to ride down. My current config works good, I feel if the channel was a bit bigger I would get better results.

Are you serious? Those rolls should not roll…? Hm… I will try that.
But the original PJ is meant to have rolling rolls - at least that’s what I can see from the demo videos on their website.

JJ

The PJ is not meant to roll but to grip and pull at the base of your dick. It’s meant to grip and pull like a dryjelq would. If the PJ or any other similar product rolled over your skin, there would be no significant pressure being applied to effect an internal structural change.

Sounds like a winner the jelg gets to the hands after ten mins I like this ideal thanks .