Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Using the ultrasound for therapeutic heat in PE

Originally Posted by BiggerPenis73
I assume you meant to say that as long as your BPFSL>BPEL you will target girth only ?

What are your girth exercises?

No. I meant to say when BPFSL = BPEL I will target girth only. This is because at that point, is basically not possible to gain more length. Once the BPFSL = BPEL, it means your BPEL has reached the limit of the septum. Therefore you can only grow sideways. i.e., EG. Only when your BPFSL > BPEL, that means your BPEL hasn’t catch up yet to the length of the septum, that means you till have room to grow in length.

This is why in my case, I target length. Once my length (BPEL) catches up with BPFSL (septum) I could go and grow sideways to increase Girth. But I chose not to. Instead, I apply the UltraSound therapy to grow my septum once again (BPFSL), create a new gap to grow more in length.

As far as girth exercise, clamping and bends under controlled PGE-1 induced priapism.


Period 1: 06/08/2020 BPFSL: 22cm (8.66") BPEL: 22cm (8.66") EG: 15.8cm (6.25") => 09/07/2020 BPFSL: 23.9cm (9.40")

Period 2: 05/01/2021 BPFSL: 24cm (9.44") BPEL: 22cm (8.66") EG: 15.8cm (6.25") => 07/24/2021 BPFSL: 25.4cm (10.00") BPEL: 23.5cm (9.25")

Goal: 1 Foot x 7.5 Inches (30.48cm x 19.05cm) NBPEL

Excellent Knowledge shared here.

I just got my US Pro 2nd editon today and performed my routine.

I am curious if I am doing this correctly while in a stretched state.

I am using the US while in my extender on the ventral side.

On the dorsal side I have a rice sock against my stomach, extender lying on top.

This really got things heated up.

Any input?

Originally Posted by Vestedvet
Excellent Knowledge shared here.

I just got my US Pro 2nd editon today and performed my routine.

I am curious if I am doing this correctly while in a stretched state.

I am using the US while in my extender on the ventral side.

On the dorsal side I have a rice sock against my stomach, extender lying on top.

This really got things heated up.

Any input?

It might have some effect, but it seems like you ae not following the scientific method of application of the therapy. Each session is composed by a stress relaxation, followed by US heating with continuous stress relaxation and a period of cool down under tension. This of course while methodically measuring before and after.


Period 1: 06/08/2020 BPFSL: 22cm (8.66") BPEL: 22cm (8.66") EG: 15.8cm (6.25") => 09/07/2020 BPFSL: 23.9cm (9.40")

Period 2: 05/01/2021 BPFSL: 24cm (9.44") BPEL: 22cm (8.66") EG: 15.8cm (6.25") => 07/24/2021 BPFSL: 25.4cm (10.00") BPEL: 23.5cm (9.25")

Goal: 1 Foot x 7.5 Inches (30.48cm x 19.05cm) NBPEL

Originally Posted by Kyrpa
Did you wait until the pre-warming procedure finished before putiing the H setting on.

Is this why I am feeling a strong burning sensation every time I try to use two 1mhz US Pro 2000?

When I begin to use them at Medium intensity, it feels like I am burning my shaft! No matter how much gel I use or how quickly I move them. It feels like I can only use one at a time.

Originally Posted by DantheMan2020
Is this why I am feeling a strong burning sensation every time I try to use two 1mhz US Pro 2000?

When I begin to use them at Medium intensity, it feels like I am burning my shaft! No matter how much gel I use or how quickly I move them. It feels like I can only use one at a time.


How are they placed in comparison to each other. The distance, direction and possible angle between? .
Where exactly do you feel the burning sensation and where not?


START 18/13.15 cm Jul 24th 18 (7.09/5.18") NOW 22.5/15.2 cm Fer 12th 20 (8.86/5.98") GOAL 8.5"/ 6"

When connective tissue is stretched within therapeutic temperatures ranging 102 to 110 F (38.9- 43.3 C), the amount of structural weakening produced by a given amount of tissue elongation varies inversely with the temperature. This is apparently related to the progressive increase in the viscous flow properties of the collagenous tissue when it is heated. (Warren et al (1971,1976)

Originally Posted by Kyrpa
How are they placed in comparison to each other. The distance, direction and possible angle between? .
Where exactly do you feel the burning sensation and where not?

I place them about an inch apart, never touching and both flat on the bottom of my shaft because I am OTL so my dorsal is on my groin.

The pain is along the surface.

Only at L intensity I do not feel it. When I use one transducer I can handle M no problem.

Is there a warm up I should do?

Originally Posted by DantheMan2020
I place them about an inch apart, never touching and both flat on the bottom of my shaft because I am OTL so my dorsal is on my groin.

The pain is along the surface


Apply surface or the opposite surface against the quad?
You said you have lots of gel. Is that also true between shaft and the quad?

Also, don’t remember if you mentioned the size of the shaft area you are heating


START 18/13.15 cm Jul 24th 18 (7.09/5.18") NOW 22.5/15.2 cm Fer 12th 20 (8.86/5.98") GOAL 8.5"/ 6"

When connective tissue is stretched within therapeutic temperatures ranging 102 to 110 F (38.9- 43.3 C), the amount of structural weakening produced by a given amount of tissue elongation varies inversely with the temperature. This is apparently related to the progressive increase in the viscous flow properties of the collagenous tissue when it is heated. (Warren et al (1971,1976)

Originally Posted by Kyrpa
Apply surface or the opposite surface against the quad?
You said you have lots of gel. Is that also true between shaft and the quad?

I place my shaft dorsal side on my thigh and apply the gel to the ventral (bottom) part of my shaft that is then showing face-up

I use lots of gel. Sometimes the gel spreads to the sides but never in between my thigh and dorsal shaft.

Does that make sense?

Only at L intensity I don’t feel the burn. When I start with M I immediately feel it

Originally Posted by DantheMan2020
I place them about an inch apart, never touching and both flat on the bottom of my shaft because I am OTL so my dorsal is on my groin.

The pain is along the surface.

Only at L intensity I do not feel it. When I use one transducer I can handle M no problem.

Is there a warm up I should do?

M option is working on pulsed cycle 80% on 20 off with 50% overall intensity of 0.8w/cm^2.

Seriously don’t know what you are experiencing.
I will try to replicate the setup. Honestly never tried the M setting on dual application.


START 18/13.15 cm Jul 24th 18 (7.09/5.18") NOW 22.5/15.2 cm Fer 12th 20 (8.86/5.98") GOAL 8.5"/ 6"

When connective tissue is stretched within therapeutic temperatures ranging 102 to 110 F (38.9- 43.3 C), the amount of structural weakening produced by a given amount of tissue elongation varies inversely with the temperature. This is apparently related to the progressive increase in the viscous flow properties of the collagenous tissue when it is heated. (Warren et al (1971,1976)

Originally Posted by DantheMan2020
I place my shaft dorsal side on my thigh and apply the gel to the ventral (bottom) part of my shaft that is then showing face-up

I use lots of gel. Sometimes the gel spreads to the sides but never in between my thigh and dorsal shaft.

Does that make sense?

Only at L intensity I don’t feel the burn. When I start with M I immediately feel it

Apply the gel on the skin of your thigh too. Make it a continuous platform for the waves to travel.
I also do shave the place where I put the shaft.


START 18/13.15 cm Jul 24th 18 (7.09/5.18") NOW 22.5/15.2 cm Fer 12th 20 (8.86/5.98") GOAL 8.5"/ 6"

When connective tissue is stretched within therapeutic temperatures ranging 102 to 110 F (38.9- 43.3 C), the amount of structural weakening produced by a given amount of tissue elongation varies inversely with the temperature. This is apparently related to the progressive increase in the viscous flow properties of the collagenous tissue when it is heated. (Warren et al (1971,1976)

Originally Posted by Kyrpa
M option is working on pulsed cycle 80% on 20 off with 50% overall intensity of 0.8w/cm^2.

Seriously don’t know what you are experiencing.
I will try to replicate the setup. Honestly never tried the M setting on dual application.

Thanks Kyrpa I really appreciate it. It literally feels like a hot burn on the surface about 10 seconds after I put it on my shaft. Very odd. Do you keep it on L setting for dual normally? What if I do M with one transducer and L with the other?

Originally Posted by Kyrpa
Apply the gel on the skin of your thigh too. Make it a continuous platform for the waves to travel.
I also do shave the place where I put the shaft.

I will also shave that part of the thigh/groin too

So while doing some research into various methods to get rid of my fat pad (which covers up around 1 inch of my shaft), I stumbled upon a few things that might have a cross-over utility for PE as well.

Some of these at-home "laser lipo" machines work by heating the internal fat tissues with lasers to cause them to leak.

Like this one: https://smile.a … /dp/B07GL2G3HD/

^^^ if that can heat up fat enough to cause leakage, it may be good to place over the penis while doing exercises. Might possibly be a 2-for-1 deal where you heat the internal penis tissues and simultaneously lose fat around the penis?

Then there are other machines you can buy with utilize seem to use ultrasound and "cavitation" to destroy fat… like this one = 9-1 Ultrasonic Cavitation RF Vacuum Radio Frequency Body Slimming Beauty Machine | eBay

and that machine actually looks pretty promising, but then I watched this video demonstrating its efffect on a piece of fatty meat, and I am concerned it actually caused the meat to reduce in size and not just the fat itself… which perhaps the word "cavitation" might indicate ??

check this video =

Privacy info: Clicking on this image will enable content from www.youtube.com. Privacy friendly version via Piped.

what do you guys think

[MS-76D1SB] Unoisetion Cavitation SMART 3D RF Microcurrent Facial Toning

^^^ the specs for the ultrasound on this machine are there if you scroll down.. it looks like this may have both an extremely powerful setting and also a setting more in line with what you guys are already using… but its above my head to try to figure it out… would one of you guys take a look

Top

All times are GMT. The time now is 08:56 AM.