Hi everyone,Almost exactly three years ago today I received my Bib. Not long after I began using a CTC 4000 electric pump. Eventually, I developed a routine where I first hung and then pumped. During this time I have increased my erect volume from 12.162 to 25.216!
I have not posted because I did not have anything to contribute…until now. Sorry for the long post
.
A couple of months ago I started doing something that some have said can’t be done. I did this based upon information from a pm and from reading this thread at PEGym:http://www.pegy m.com/forums/bl … dicated-PE.html
The above individual apparently puts oil in the tube and hangs weights straight down. I use air and cannot get a good enough seal to hang straight down. So I use a pulley system where the pulley hangs from a large hook screwed into a beam on the wall above my desk alcove. I use a heavy-duty nylon rope/line which is connected to the tube (double-looped around the tube) on one end and the weights are connected to an S hook on the other end. This arrangement allows me to sit in my chair and tilt my fat pad so it remains flush to the base of the tube.
Experimenting with different sized tubes I found that the 2.25” size is best for me. With this system I have been hanging up to 30 lbs. It is a little tricky but the bottom half of my shaft expands to the wall of the pump and holds the tube in place.
At higher weights I need to go up to 10 Hg to keep the tube sealed to my minimal fat pad—at least temporarily. After a few minutes of expanding in the tube I can usually reduce the pressure to 7.5 Hg without the tube breaking its seal. At lower weights of 17.5 lbs or less I usually start at 7.5 Hg and then can reduce to 5.0 Hg.NOTE: Keep in mind that I am conditioned. Hanging with the Bib for three years using weights as high as 37 ½ lbs, and pumping for almost as long has been a learning and conditioning experience. Because of all this, I feel comfortable doing what I am doing. Others should only consider this routine at much lower pressure.
Even with my conditioning, at the higher pressures I usually use a gauze wrap over my glans and then place a plastic cap (from a small spray can) over the wrap and then place a silicone sleeve over everything to hold it all together (kind of like the LG hanger set-up). This helps protect the glans and the upper half of the shaft.
I also use ball rings for both low-hanging balls and to keep too much scrotal skin from filling the tube. Some skin is OK as it helps create the needed seal. When all the planets align, I have a huge dick and low hanging balls—the best of both worlds IMHO.
This is an awesome set-up! The combination of the pump expanding everything and the weights stretching the expanded cells is affording me an immense size. The volume increase mentioned at the beginning of this post is pre-pumping—and only after waiting until the next day. When I come out of the pump I am 7.1” flaccid length and 7” + flaccid girth, depending on where I measure along the shaft. This size slowly dissipates over the coming hours but still is large 24 hours later.
Because there are so many moving parts in all of this I will need to keep doing this for a while in order to determine permanence. But I can’t help thinking that the synergy of pumping and hanging may be a game changer—at least for me. I like a big fat flaccid—and a big fat erection!
Sounds like a killer routine.. when stretching the tube several minutes at high vacuum level.
Sounds crazy intense!
Starting size: 7.48" X 5.51" Currently: 10.1" X 6.4"
Heat is the key!
