Originally Posted by thoughtfulgold
While I am motivated to seek gains in the girth category I have always prioritized curve correction over any other PE goal. At this point I realize that while a 2” diameter cylinder is uncomfortable to use, when I insert my fully erect penis in one of my 2” diameter tubes it straightens by default. My penis frictions the walls of the cylinder pretty heavily and obviously is a poor choice as far as sizing is concerned. Pressurizing it will be likely uncomfortable as well but if I buy a 2” diameter velseal cylinder and get the EZ angle it likely will be the single biggest move I can make towards drastic curve correction faster than my current path. Using the 2 and 1/4 tube it does help and obviously I have seen that benefit. The logic follows that if I were to use a tighter and more insistent mold it would work faster and target the bent areas more intensely.It just is another expense to buy a new EZ angle tube. And more time to spend once I’m done healing from the bump on the side of my shaft. But my motivation knows no limits and my determination has no boundary. I have set a goal and I have demanded a solution and now that I have found it I literally have no choice but to use it because I asked for nothing more.
I am still healing and off pumping for another week or so. Trying to wait out this bump but I will see what i can do about it this week at the doctor if I am not better by Wednesday.
I really don’t know but will not the tighter tube offer a length component as well?